AutoCodes – Ford – P1151 2001 Ford F150

P1151 2001 Ford F150 Code - Lack of Upstream Heated Oxygen Sensor Switch Sensor Indicates Lean Bank 2

Quick Answer

The Heated Oxygen Sensor (HO2S) Monitor is an on-board strategy designed to monitor the HO2S sensors for a malfunction or deterioration that can affect emissions. Common causes include Faulty Upstream Oxygen Sensor Bank 2, Fuel pressure high or low, MAF sensor dirty/defective. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

What it means: P1151 2001 Ford F150 indicates Lack of Upstream Heated Oxygen Sensor Switch Sensor Indicates Lean Bank 2.
Common causes: Common causes include Faulty Upstream Oxygen Sensor Bank 2, Fuel pressure high or low, MAF sensor dirty/defective.
Severity: High - diagnose this code as soon as possible.
Can I drive?: Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 7,272

How popular is this code, among other codes? Low

Repair Importance Level

Urgent (Diagnose now) (3 / 3)

Repair Difficulty Level

Intermediate (2 / 3)

What is this?

Table of contents Created and updated by William Orellana on May 03, 2019

Description
Possible Causes
How To Fix
Tech Notes
Cost to Diagnose
FAQs
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P1151 2001 Ford F150 Description

The Heated Oxygen Sensor (HO2S) Monitor is an on-board strategy designed to monitor the HO2S sensors for a malfunction or deterioration that can affect emissions. Under specific conditions, the fuel control or upstream HO2S sensors are checked for proper output voltage and response rate (the time it takes to switch from lean to rich or rich to lean). Downstream HO2S sensors used for Catalyst Monitor are also monitored for proper output voltage. Input is required from the Engine Coolant Temperature (ECT) or Cylinder Head Temperature (CHT), Inlet Air Temperature (IAT), Mass Air Flow (MAF), Throttle Position (TP) and Crankshaft Position (CKP) sensors to activate the HO2S Monitor. The Fuel System Monitor and Misfire Detection Monitor must also have completed successfully before the HO2S Monitor is enabled.
• The HO2S sensor senses the oxygen content in the exhaust flow and outputs a voltage between zero and 1.0 volt. Lean of stoichiometric (air/fuel ratio of approximately 14.7:1 for gasoline engines), the HO2S will generate a voltage between zero and 0.45 volt. Rich of stoichiometric, the HO2S will generate a voltage between 0.45 and 1.0 volt.
• The HO2S Monitor evaluates both the upstream (Fuel Control) and downstream (Catalyst Monitor) HO2S for proper function.
• Once the HO2S Monitor is enabled, the upstream HO2S signal voltage amplitude and response frequency are checked. Excessive voltage is determined by comparing the HO2S signal voltage to a maximum calibratable threshold voltage.
• A fixed frequency closed loop fuel control routine is executed and the upstream HO2S voltage amplitude and output response frequency are observed. A sample of the upstream HO2S signal is evaluated to determine if the sensor is capable of switching or has a slow response rate.
• An HO2S heater circuit fault is determined by turning the heater on and off and looking for a corresponding change in the OSM and by
measuring the current going through the heater circuit.
• The MIL is activated after a fault is detected on two consecutive OBD II drive cycles.

OBDII Code P1151 2001 Ford F150 - Lack of Upstream Heated Oxygen Sensor Switch Sensor Indicates Lean Bank 2 - AutoCodes.com — P1151 2001 Ford F150 Code - Lack of Upstream Heated Oxygen Sensor Switch Sensor Indicates Lean Bank 2

What does this mean?

What are the Possible Causes of the DTC P1151 2001 Ford F150?

Faulty Upstream Oxygen Sensor Bank 2
Fuel pressure high or low
MAF sensor dirty/defective
Vacuum leak on engine
Leaking fuel injector or fuel pressure regulator
Faulty Powertrain Control Module (PCM)

How to Fix the DTC P1151 2001 Ford F150?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What does this mean?

Code Tech Notes

The code means that the Powertrain Control Module (PCM) has detected a lean system, which means that there is either not enough fuel or and excessive amount of air in the system. Start by checking for vacuum leaks.

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1151 2001 Ford F150 code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P1151 2001 Ford F150 code?

Need more information on how to fix the P1151 2001 Ford F150 code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1151 2001 Ford F150 code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.

Frequently Asked Questions about P1151 2001 Ford F150 Code

1. What are the common symptoms of OBDII code P1151 in a 2001 Ford F150?

- Common symptoms include poor fuel economy, rough engine idle, lack of power, and the Check Engine light being illuminated.

2. What does the OBDII code P1151 for a 2001 Ford F150 indicate?

- The code indicates a lack of switching for the upstream heated oxygen sensor on Bank 2, signaling a lean fuel mixture condition.

3. What are the possible causes of OBDII code P1151 in a 2001 Ford F150?

- Potential causes include a faulty upstream heated oxygen sensor, vacuum leaks, a clogged fuel filter, leaking intake manifold gaskets, or a malfunctioning fuel pressure regulator.

4. How can I diagnose the cause of OBDII code P1151 in my 2001 Ford F150?

- You can start by visually inspecting the oxygen sensor and related components for any signs of damage or wear. Additionally, performing a fuel pressure test and checking for vacuum leaks can help pinpoint the issue.

5. What are some repair tips for fixing OBDII code P1151 in a 2001 Ford F150?

- Begin by replacing the upstream heated oxygen sensor on Bank 2. Ensure all connections are secure and there are no leaks in the intake system. Clear the trouble code and drive the vehicle to see if the issue has been resolved.

6. Can driving with OBDII code P1151 in a 2001 Ford F150 cause further damage?

- Continuing to drive with a lean fuel mixture condition can potentially lead to damage to the engine, particularly the catalytic converter. It is recommended to address the issue promptly.

7. How much does it cost to repair OBDII code P1151 in a 2001 Ford F150?

- The cost of repair can vary depending on the underlying cause. Replacing the upstream heated oxygen sensor can range from $100 to $300, while addressing other issues like vacuum leaks or fuel system problems may incur additional costs.

8. Can I clear the OBDII code P1151 in my 2001 Ford F150 with a simple reset?

- While clearing the code may temporarily turn off the Check Engine light, it will not fix the underlying issue causing the lean fuel mixture condition. It is recommended to diagnose and repair the problem to prevent further issues.