P1137 2003 NISSAN SENTRA - Swirl Control Valve Control Position Sensor Circuit
P1137 2003 NISSAN SENTRA Possible Causes
- Faulty Swirl Control Valve Control Position Sensor
- Swirl Control Valve Control Position Sensor harness is open or shorted
- Swirl Control Valve Control Position Sensor circuit poor electrical connection
- Faulty Swirl Control Valve
How do I fix code P1137 2003 NISSAN SENTRA?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Cost of diagnosing the P1137 2003 NISSAN SENTRA code
Labor: 1.0The cost of diagnosing the P1137 2003 NISSAN SENTRA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?An excessively low or high voltage from the sensor is sent to Engine Control Module (ECM).
- Engine Light ON (or Service Engine Soon Warning Light)
P1137 2003 NISSAN SENTRA DescriptionSwirl control valve position sensor is installed on the intake manifold.
The sensor is connected to the front end of the valve shaft of the swirl control valve.
The sensor responds to the valve shaft movement. This sensor is a kind of potentiometer which transforms the swirl control valve position into output voltage, and emits the voltage signal to the Engine Control Module (ECM).
More InformationNeed more information on how to fix the P1137 2003 NISSAN SENTRA code?
Get Access to Factory Service Manuals
Need more help?Get the P1137 2003 Nissan Sentra code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1137 2003 Nissan Sentra code? Have you replaced any parts?
Any information is appreciated. Thanks