AutoCodes
 
OBDII Code List
 
P1132 2004 NISSAN SENTRA

P1132 2004 NISSAN SENTRA - Swirl Control Valve Circuit

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3   
Comments  |  Add Comment

Possible causes

  • Faulty Swirl Control Valve
  • Swirl Control Valve harness is open or shorted
  • Swirl Control Valve circuit poor electrical connection

When is the code detected?

An improper voltage signal is sent to Engine Control Module (ECM).

Possible symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P1132 2004 Nissan Sentra Description

Swirl control valve consists of actuator and valve. The valve is installed in the intake manifold, and the actuator is connected to the rear end of the valve shaft.

The swirl control valve uses a step motor which has four winding phases. It operates according to the output pulse signal of the Engine Control Module (ECM). Two windings are turned ON and OFF in sequence. Each time an ON pulse is issued, the valve opens or closes. When no change in the control position is needed, the ECM does not issue the pulse signal. A certain voltage signal is issued so that the valve remains at that particular opening.

OBDII Code P1132 2004 Nissan Sentra - Swirl Control Valve Circuit - AutoCodes.com

Need more help?

Get the P1132 2004 Nissan Sentra code diagnosed by a professional: Find a repair shop in your area

Related Information

P1132 2004 NISSAN SENTRA Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1132 2004 Nissan Sentra code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧