P1117 2008 TOYOTA PRIUS Code - Coolant Temperature Sensor Circuit Stack for Coolant Heat Storage System
Table of contents
Share:
P1117 2008 TOYOTA PRIUS code possible causes
- Coolant Heat Storage Tank
- Faulty Engine Coolant Temperature (ECT) sensor for CHS (Coolant Heat Storage)
- Low engine coolant level
- Engine Coolant Temperature (ECT) sensor for HST harness is open or shorted
- Engine Coolant Temperature (ECT) sensor for HST electrical circuit poor connection
- Faulty engine coolant thermostat
How do I fix the P1117 2008 TOYOTA PRIUS code?
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.Cost of diagnosing the P1117 2008 TOYOTA PRIUS code
Labor: 1.0
The cost of diagnosing the P1117 2008 TOYOTA PRIUS code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.What are P1117 2008 TOYOTA PRIUS code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
P1117 2008 TOYOTA PRIUS code description
This system uses an electric pump to supply hot coolant stored in the coolant heat storage tank into the cylinder head of the engine, in order to optimize engine starting combustion and reduce the amount of unburned gas that is discharged while the engine is started. Before the engine starts, the ECM operates the electric water pump to direct the hot coolant in the heat storage tank into the engine, in order to heat the cylinder head (this process is called "preheat mode"). The duration of the operation of the electric water pump is variable, depending on the temperature of the cylinder head. During the normal operation of the engine, the water valve opens the passage between the cylinder head and the heater and closes the passage between the cylinder head and the tank. During preheat mode in which the cylinder head is heated, the water valve opens the passage between the tank and the cylinder head, in order to allow the coolant to flow from the tank to the cylinder head. At this time, in order to warm up the intake port quickly before the engine is started, the coolant flows in the reverse direction.
Need more information with the P1117 2008 TOYOTA PRIUS code?
Need more information on how to fix the P1117 2008 TOYOTA PRIUS code? Get Access to Factory Service ManualsNeed help with a P1117 2008 TOYOTA PRIUS code?
Get the P1117 2008 Toyota Prius code diagnosed by a professional: Find a repair shop in your areaP1117 2008 TOYOTA PRIUS code comments
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1117 2008 Toyota Prius code? Have you replaced any parts?Any information is appreciated. Thanks