AutoCodes - OBDII Code List - P1117 2006 FORD FUSION

P1117 2006 FORD FUSION - Engine Coolant Temperature Sensor Intermittent

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3    What is this?
Comments  |  Add Comment

P1117 2006 FORD FUSION Possible Causes

  • Low Engine Coolant Level
  • Faulty Engine Coolant Temperature (ECT) sensor
  • Engine Coolant Temperature (ECT) sensor harness is open or shorted
  • Engine Coolant Temperature (ECT) sensor electrical circuit poor connection
  • Faulty Engine Coolant Thermostat
  • Damaged Powertrain Control Module (PCM)

How do I fix code P1117 2006 FORD FUSION

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Tech Notes

Monitor the ECT on a scan tool. Look for sudden changes in the reading when the harness is wiggled or the sensor is tapped.

Cost of diagnosing the P1117 2006 FORD FUSION code

Labor: 1.0

The cost of diagnosing the P1117 2006 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine Overheating

P1117 2006 Ford Fusion Description

The Engine Coolant Temperature (ECT) Sensor is a thermistor device in which resistance changes with temperature. The electrical resistance of a thermistor decreases as the temperature increases, and the resistance increases as the temperature decreases. The varying resistance changes the voltage drop across the sensor terminals and provides electrical signals to the Powertrain Control Module (PCM) corresponding to temperature.
Thermistor-type sensors are considered passive sensors. A passive sensor is connected to a voltage divider network so varying the resistance of the passive sensor causes a variation in total current flow. Voltage that is dropped across a fixed resistor (pull-up resister) in series with the sensor resistor determines the voltage signal at the PCM. This voltage signal is equal to the reference voltage minus the voltage drop across the fixed resistor.
The ECT measures the temperature of the engine coolant. The PCM uses the ECT input for fuel control and for cooling fan control. There are 3 types of ECT sensors; threaded, push-in, and twist-lock. The ECT sensor is located in an engine coolant passage.
OBDII Code P1117 2006 Ford Fusion - Engine Coolant Temperature Sensor Intermittent - AutoCodes.com

P1117 2006 FORD FUSION More Information

Need more information on how to fix the P1117 2006 FORD FUSION code?
Get Access to Factory Service Manuals

Need more help?

Get the P1117 2006 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1117 2006 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧