P1116 2004 TOYOTA PRIUS - Coolant Temperature Sensor Circuit Stack for Coolant Heat Storage System
P1116 2004 TOYOTA PRIUS Possible Causes
- Coolant Heat Storage Tank
- Faulty Engine Coolant Temperature (ECT) sensor for CHS (Coolant Heat Storage)
- Low engine coolant level
- Engine Coolant Temperature (ECT) sensor for HST harness is open or shorted
- Engine Coolant Temperature (ECT) sensor for HST electrical circuit poor connection
- Faulty engine coolant thermostat
How do I fix code P1116 2004 TOYOTA PRIUS?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Cost of diagnosing the P1116 2004 TOYOTA PRIUS code
Labor: 1.0The cost of diagnosing the P1116 2004 TOYOTA PRIUS code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
- Engine Light ON (or Service Engine Soon Warning Light)
P1116 2004 TOYOTA PRIUS DescriptionThe coolant heat storage (CHS) tank outlet temperature sensor is used for monitoring coolant temperature in the vicinity of the outlet port of the heat storage tank of the CHS system. The resistance of the sensor increases when the CHS tank outlet temperature is low, and conversely, the resistance decreases when the temperature is high. The changes in resistance are reflected in the voltage that is output by the sensor. The ECM monitors the sensor voltage and uses this value to control CHS system properly.
More InformationNeed more information on how to fix the P1116 2004 TOYOTA PRIUS code?
Get Access to Factory Service Manuals
Need more help?Get the P1116 2004 Toyota Prius code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1116 2004 Toyota Prius code? Have you replaced any parts?
Any information is appreciated. Thanks