AutoCodes - OBDII Code List - P1106 CHEVROLET

P1106 CHEVROLET - Manifold Absolute Pressure Sensor Circuit Intermittent High Voltage

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3    What is this?
Comments  |  Add Comment

P1106 CHEVROLET Possible Causes

  • Faulty Manifold Absolute Pressure (MAP) sensor
  • Manifold Absolute Pressure (MAP) sensor harness is open or shorted
  • Manifold Absolute Pressure (MAP) sensor circuit poor electrical connection

How do I fix code P1106 CHEVROLET

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the P1106 CHEVROLET code

Labor: 1.0

The cost of diagnosing the P1106 CHEVROLET code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the code detected?

If the Powertrain Control Module (PCM) detects a Manifold Absolute Pressure (MAP) sensor signal voltage that is intermittently high, the P1106 code will set.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine rough idle
  • Engine hesitation

P1106 Chevrolet Description

The Manifold Absolute Pressure (MAP) sensor responds to pressure changes in the intake manifold. The pressure changes occur based on the engine load. The MAP sensor has the following circuits:
- 5-volt reference circuit
- Low reference circuit
- MAP sensor signal circuit
The Powertrain Control Module (PCM) supplies 5 volts to the MAP sensor on the 5-volt reference circuit. The PCM also provides a ground on the low reference circuit. The MAP sensor provides a signal to the PCM on the MAP sensor signal circuit which is relative to the pressure changes in the manifold. The PCM should detect a low signal voltage at a low MAP, such as during an idle or a deceleration. The PCM should detect a high signal voltage at a high MAP, such as the ignition is ON, with the engine OFF, or at a wide open throttle (WOT). The MAP sensor is also used in order to determine the barometric pressure (BARO). This occurs when the ignition switch is turned ON, with the engine OFF. The BARO reading may also be updated whenever the engine is operated at WOT. The PCM monitors the MAP sensor signal for voltage outside of the normal range.
OBDII Code P1106 Chevrolet - Manifold Absolute Pressure Sensor Circuit Intermittent High Voltage - AutoCodes.com

P1106 CHEVROLET More Information

Need more information on how to fix the P1106 CHEVROLET code?
Get Access to Factory Service Manuals

Need more help?

Get the P1106 Chevrolet code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1106 Chevrolet code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧