AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Infiniti - P1105 1996 Infiniti I30

P1105 1996 Infiniti I30 Code - Manifold Absolute Pressure/Barometric Pressure Switch Solenoid Valve

- Code Popularity: 5,759 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1105 1996 Infiniti I30?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Manifold Absolute Pressure Switch Solenoid Valve
  • Manifold Absolute Pressure Switch Solenoid Valve harness is open or shorted
  • Manifold Absolute Pressure Switch Solenoid Valve sensor poor electrical circuit connector
  • Faulty Engine Control Module (ECM)
⚠ Does your Infiniti have Safety Recalls? → Check here

How to Fix the DTC P1105 1996 Infiniti I30?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P1105 1996 Infiniti I30 Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1105 1996 Infiniti I30 code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

An excessively low or high voltage from the sensor is sent to Engine Control Module (ECM).

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine rough idle
  • Engine hesitation

Code P1105 1996 Infiniti I30 Description

The Manifold Absolute Pressure (MAP) sensor provides instantaneous manifold pressure information to the engine's Engine Control Module (ECM). The data is used to calculate air density and determine the engine's air mass flow rate, which in turn determines the required fuel metering for optimum combustion. A fuel-injected engine may alternately use a Mass Air Flow (MAF) sensor to detect the intake airflow. A typical configuration employs one or the other, but seldom both.The MAP/BARO Switch solenoid valve switches it's air flow passage according to the voltage signal sent from the ECM.

OBDII Code P1105 1996 Infiniti I30 - Manifold Absolute Pressure/Barometric Pressure Switch Solenoid Valve - AutoCodes.com
P1105 1996 Infiniti I30 Code - Manifold Absolute Pressure/Barometric Pressure Switch Solenoid Valve

Need More Information on the Code?

Need more information on how to fix the P1105 1996 Infiniti I30 code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1105 1996 Infiniti I30 code diagnosed by a professional: Find a repair shop in your area

Code P1105 1996 Infiniti I30 comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1105 1996 Infiniti I30 code? Have you replaced any parts?
Any information is appreciated. Thanks