P1101 2010 FORD FUSION - Mass Air Flow Sensor Out of Self-Test Range
P1101 2010 FORD FUSION Possible Causes
- Faulty Mass Air Flow Sensor
- Air leak before or after sensor
- Mass Air Flow Sensor harness is open or shorted
- Mass Air Flow Sensor circuit poor electrical connection
How do I fix code P1101 2010 FORD FUSIONCheck the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Cost of diagnosing the P1101 2010 FORD FUSION code
Labor: 1.0The cost of diagnosing the P1101 2010 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?The Engine Control Module (ECM) detected a Mass Air Flow (MAF) sensor signal above or below calibrated limit
- Engine Light ON (or Service Engine Soon Warning Light)
P1101 2010 Ford Fusion DescriptionThe Mass Air Flow (MAF sensor circuit is monitored by the Powertrain Control Module (PCM) for an out of range air flow (or voltage) input. If during key ON engine OFF the air flow voltage signal is greater than 0.27 volts the test fails. Likewise, if during key ON engine running, an air flow voltage signal is not within 0.46 volt to 2.44 volts, the test fails.
P1101 2010 FORD FUSION More InformationNeed more information on how to fix the P1101 2010 FORD FUSION code?
Get Access to Factory Service Manuals
Need more help?Get the P1101 2010 Ford Fusion code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1101 2010 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks