AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Cadillac - P10E3 Cadillac

P10E3 Cadillac Code - Ignition On/Start Circuit Source Bypass Relay Control Circuit High Voltage

- Code Popularity: 260 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P10E3 Cadillac?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Engine Control Module Wake-Up Relay
  • Engine Control Module Wake-Up Relay harness is open or shorted
  • Engine Control Module Wake-Up Relay circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Cadillac have Safety Recalls? → Check here

How to Fix the DTC P10E3 Cadillac?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P10E3 Cadillac Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P10E3 Cadillac code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P10E3 Cadillac Description

The Engine Control Module (ECM) contains a microprocessor used to process input data to control outputs. The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly. Relays are used to control a high-power circuit with a low power signal. The output circuit is switched to the ground to activate the component. The Diagnostic Trouble Code (DTC) will be set when the Control Circuit is short to voltage for greater than 1 s.

OBDII Code P10E3 Cadillac - Ignition On/Start Circuit Source Bypass Relay Control Circuit High Voltage - AutoCodes.com
P10E3 Cadillac Code - Ignition On/Start Circuit Source Bypass Relay Control Circuit High Voltage

Need More Information on the Code?

Need more information on how to fix the P10E3 Cadillac code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P10E3 Cadillac code diagnosed by a professional: Find a repair shop in your area

Code P10E3 Cadillac comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P10E3 Cadillac code? Have you replaced any parts?
Any information is appreciated. Thanks