AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Chevrolet - P10E2 2015 Chevrolet Silverado

P10E2 2015 Chevrolet Silverado Code - Ignition On/Start Circuit Source Bypass Relay Control Circuit Low Voltage

- Code Popularity: 167 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P10E2 2015 Chevrolet Silverado?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Engine Control Module Wake-Up Relay
  • Engine Control Module Wake-Up Relay harness is open or shorted
  • Engine Control Module Wake-Up Relay circuit poor electrical connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Chevrolet have Safety Recalls? → Check here

How to Fix the DTC P10E2 2015 Chevrolet Silverado?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P10E2 2015 Chevrolet Silverado Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P10E2 2015 Chevrolet Silverado code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P10E2 2015 Chevrolet Silverado Description

The Engine Control Module (ECM) contains a microprocessor used to process input data to control outputs. The control module controls a series of actuators to ensure optimal engine performance. The control module does this by reading values from a variety of sensors, interprets the data and adjusts the engine actuators accordingly. Relays are used to control a high-power circuit with a low power signal. The output circuit is switched to the ground to activate the component. The Diagnostic Trouble Code (DTC) will be set when the Control Circuit is short to ground for greater than 1 s.

OBDII Code P10E2 2015 Chevrolet Silverado - Ignition On/Start Circuit Source Bypass Relay Control Circuit Low Voltage - AutoCodes.com
P10E2 2015 Chevrolet Silverado Code - Ignition On/Start Circuit Source Bypass Relay Control Circuit Low Voltage

Need More Information on the Code?

Need more information on how to fix the P10E2 2015 Chevrolet Silverado code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P10E2 2015 Chevrolet Silverado code diagnosed by a professional: Find a repair shop in your area

Code P10E2 2015 Chevrolet Silverado comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P10E2 2015 Chevrolet Silverado code? Have you replaced any parts?
Any information is appreciated. Thanks