AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Buick - P1011 Buick

P1011 Buick Code - Intake Camshaft Position Actuator Park Position Bank 1

- Code Popularity: 3,013 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P1011 Buick?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low engine oil level
  • Low engine oil pressure
  • Faulty Intake Camshaft Position Actuator Bank 1
⚠ Does your Buick have Safety Recalls? → Check here

How to Fix the DTC P1011 Buick?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P1011 Buick Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P1011 Buick code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P1011 Buick Description

The Camshaft Position (CMP) actuator system enables the Engine Control Module (ECM) to change the camshaft timing of all 4 camshafts while the engine is operating. The CMP actuator assembly varies the camshaft position in response to directional changes in oil pressure. The CMP actuator solenoid controls the oil pressure that is applied to advance or retard a camshaft.
The CMP actuator assemblies have an outer housing that is driven by the engine timing chain. Inside the CMP assembly is a wheel with fixed vanes that is attached to the camshafts. The CMP actuator assemblies are also equipped with a locking pin. The locking pin prevents movement between the outer housing and the wheel vane assembly on engine start-ups. The CMP actuator is locked until sufficient oil pressure is available to control the CMP actuator. The locking pin is released by oil pressure before any movement in the CMP actuator assembly takes place. If the ECM detects that the CMP actuator is not in the locked position on a start-up, this Diagnostic Trouble Code (DTC) sets.

OBDII Code P1011 Buick - Intake Camshaft Position Actuator Park Position Bank 1 - AutoCodes.com
P1011 Buick Code - Intake Camshaft Position Actuator Park Position Bank 1

Need More Information on the Code?

Need more information on how to fix the P1011 Buick code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P1011 Buick code diagnosed by a professional: Find a repair shop in your area

Code P1011 Buick comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P1011 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks