AutoCodes - OBDII Code List - P1000 DODGE

P1000 DODGE - On Board Diagnostic System Readiness Test Not Complete

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3    What is this?
Table of contents

P1000 DODGE Possible Causes

  • The vehicle is new from the factory.
  • Battery or Powertrain Control Module (PCM) had recently been disconnected.
  • An OBD monitor failure occurred before completion of an OBD drive cycle.
  • PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool.

How do I fix code P1000 DODGE?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Connect Your Car To The Future

Cost of diagnosing the P1000 DODGE code

Labor: 1.0

The cost of diagnosing the P1000 DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P1000 DODGE Description

The On Board Diagnostic (OBD) monitors are performed during the OBD Drive Cycle. P1000 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check.
OBDII Code P1000 Dodge - On Board Diagnostic System Readiness Test Not Complete - AutoCodes.com

More Information

Need more information on how to fix the P1000 DODGE code?
Get Access to Factory Service Manuals

Need more help?

Get the P1000 Dodge code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1000 Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧