P1000 2011 FORD FUSION - On Board Diagnostic System Readiness Test Not Complete
P1000 2011 FORD FUSION Possible Causes
- The vehicle is new from the factory.
- Battery or Powertrain Control Module (PCM) had recently been disconnected.
- An OBD monitor failure occurred before completion of an OBD drive cycle.
- PCM Diagnostic Trouble Codes (DTC) have recently been cleared with a scan tool.
How do I fix code P1000 2011 FORD FUSION?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Cost of diagnosing the P1000 2011 FORD FUSION code
Labor: 1.0The cost of diagnosing the P1000 2011 FORD FUSION code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?If DTC P1000 is triggered after DTCs have been cleared, all engine management OBD diagnostic monitor drive cycles have not been cleared.
- Engine Light ON (or Service Engine Soon Warning Light)
P1000 2011 FORD FUSION DescriptionThe On Board Diagnostic (OBD) monitors are performed during the OBD Drive Cycle. P1000 is stored in continuous memory if any of the OBD monitors do not carry out their full diagnostic check.
More InformationNeed more information on how to fix the P1000 2011 FORD FUSION code?
Get Access to Factory Service Manuals
Need more help?Get the P1000 2011 Ford Fusion code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P1000 2011 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks