P0987 JEEP - 4C Hydraulic Pressure Test
P0987 JEEP Possible Causes
- Low or dirty fluid
- Faulty Line Pressure Sensor
- Line Pressure Sensor harness is open or shorted
- Line Pressure Sensor circuit poor electrical connection
How do I fix code P0987 JEEP?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?
Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge
Cost of diagnosing the P0987 JEEP code
Labor: 1.0The cost of diagnosing the P0987 JEEP code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the code detected?While performing a transmission internal test the Transmission Control Module (TCM) detected that the Pressure Switch did not close 2 times
- Engine Light ON (or Service Engine Soon Warning Light)
P0987 JEEP DescriptionThe Transmission Control Module (TCM) monitors the Transmission Fluid Pressure Sensor/Switch signal. The TCM sets the OBDII code when the Transmission Fluid Pressure Sensor/Switch is not to factory specifications.
More InformationNeed more information on how to fix the P0987 JEEP code?
Get Access to Factory Service Manuals
Need more help?Get the P0987 Jeep code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0987 Jeep code? Have you replaced any parts?
Any information is appreciated. Thanks