AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Buick - P0976 Buick

P0976 Buick Code - Shift Solenoid 'B' Short To Ground

- Code Popularity: 1,727 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0976 Buick?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low transmission fluid level
  • Dirty transmission fluid
  • Faulty Transmission Control Solenoid Valve
  • Transmission Control Solenoid Valve harness is open or shorted
  • Transmission Control Solenoid Valve circuit poor electrical connection
⚠ Does your Buick have Safety Recalls? → Check here

How to Fix the DTC P0976 Buick?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0976 Buick Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0976 Buick code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0976 Buick Description

The shift solenoid 2 is part of the control solenoid valve assembly which has no serviceable parts. The shift solenoid 2 is a normally closed ON/OFF solenoid and is controlled by the Transmission Control Module through a low side driver. When the shift solenoid 2 is energized, shift solenoid 2 fluid pressure is directed to the clutch select valve 3. Power to the shift solenoid 2 is supplied by the Transmission Control Module through a high-side driver. The high-side driver protects the circuit and components from excessive current flow. If excessive current flow is detected, the high side driver will turn OFF. When the fault is corrected, the high-side driver will reset. The Diagnostic Trouble Code (DTC) will be set when the Transmission Control Module detects an internal low voltage electrical malfunction of the shift solenoid 2 control circuit when the shift solenoid 2 is commanded OFF for 2 seconds.

OBDII Code P0976 Buick - Shift Solenoid 'B' Short To Ground - AutoCodes.com
P0976 Buick Code - Shift Solenoid 'B' Short To Ground

Need More Information on the Code?

Need more information on how to fix the P0976 Buick code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0976 Buick code diagnosed by a professional: Find a repair shop in your area

Code P0976 Buick comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0976 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks