Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.
There is a Factory Service Bulletin for the Jeep following models:
2005-2006 Jeep Liberty
2005-2006 Jeep Cherokee
2005-2006 Jeep Grand Cherokee
2006 Jeep Commander
Jeep Factory Service Bulletin OBDII Code P0944
To diagnose the P0944 Jeep code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.
The Loss of Prime Test is used to prevent transmission defaults and erroneous fault codes during temporary loss of pump prime that may occur with low transmission fluid under severe braking conditions, start-up, etc. and to point towards more subtle problems such as a plugged or ruptured oil filter. The Loss of Prime fault is set by a loss of hydraulic pressure in the transmission system. This condition, if sustained, will result in the vehicle being unable to move.
Need more information on how to fix the P0944 Jeep code? Get Access to Factory Service Manuals
Get the P0944 Jeep code diagnosed by a professional: Find a repair shop in your area
Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0944 Jeep code? Have you replaced any parts?
Any information is appreciated. Thanks