P0891 JEEP - TCM Power Relay Sense Circuit High
P0891 JEEP Possible Causes
- Faulty Transmission Control Module (TCM) Power Relay
- Transmission Control Module (TCM) Power Relay harness is open or shorted
- Transmission Control Module (TCM) Power Relay circuit poor electrical connection
How do I fix code P0891 JEEP?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
Cost of diagnosing the P0891 JEEP code
Labor: 1.0The cost of diagnosing the P0891 JEEP code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
- Engine Light ON (or Service Engine Soon Warning Light)
P0891 JEEP DescriptionThe transmission control relay is used to supply power to the solenoid pack when the transmission is in normal operating mode. When the relay is off, no power is supplied to the solenoid pack and the transmission is in Limp-in mode. The relay output is fed back to the Powertrain Control Module (PCM). It is referred to as the Transmission Control Relay Output circuit or switched battery.
Immediately after a controller reset (ignition key turned to the run position or after cranking engine), the PCM verifies that the relay contacts are open by checking for no voltage at the switched battery terminals. After this is verified, the voltage at the pressure switches is checked. There should be no voltage on the pressure switches at this time. The PCM will then activate the relay.
More InformationNeed more information on how to fix the P0891 JEEP code?
Get Access to Factory Service Manuals
Need more help?Get the P0891 Jeep code diagnosed by a professional: Find a repair shop in your area
CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0891 Jeep code? Have you replaced any parts?
Any information is appreciated. Thanks