AutoCodes - OBDII Code List - P0883 DODGE

P0883 DODGE - TCM Power Input Signal High

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

P0883 DODGE Possible Causes

  • Transmission Control Module (TCM) Power and/or Ground connection
  • Faulty Transmission Solenoids
  • Faulty Transmission Control Module (TCM)
  • Faulty Powertrain Control Module (PCM)
  • Transmission Control Module (TCM) harness is open or shorted
  • Transmission Control Module (TCM) circuit poor electrical connection

How do I fix code P0883 DODGE?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
How much do you know about cars?

Take the AutoCodes.com automotive tests and turbo-charge your car repair knowledge

Play Now

Cost of diagnosing the P0883 DODGE code

Labor: 1.0

The cost of diagnosing the P0883 DODGE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P0883 DODGE Description

The Transmission Control Output circuit is used to supply power to the Transmission Solenoid/TRS Assembly and to the PCM when in normal operating mode. The purpose of the Transmission Output circuit is to allow the Transmission Control System to turn off the power to the Transmission Solenoid/TRS Assembly in event that the transmission should need to be placed into limp-in mode due to a DTC.
After a Powertrain Control Module (PCM) reset, (ignition switch turned to the run position, or after cranking the engine) the Transmission Control System verifies that the Transmission Output circuit is open by checking for voltage on the Transmission Output circuits before the Transmission Control System request for the circuit to be powered up. The request is sent by a direct circuit control from the PCM to the TIPM. If voltage is detected on the Transmission Output circuits before the request is sent, the DTC will set.
OBDII Code P0883 Dodge - TCM Power Input Signal High - AutoCodes.com

More Information

Need more information on how to fix the P0883 DODGE code?
Get Access to Factory Service Manuals

Need more help?

Get the P0883 Dodge code diagnosed by a professional: Find a repair shop in your area

Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0883 Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?