AutoCodes
 
OBDII Code List
 
P0852 BUICK

P0852 BUICK - Park/Neutral Position Switch Circuit High Voltage

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3   
Comments  |  Add Comment

P0852 BUICK Possible Causes

  • Faulty Park/Neutral Switch
  • Park/Neutral Switch harness is open or shorted
  • Park/Neutral Switch circuit poor electrical connection

How do I fix code P0852 BUICK

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Cost of diagnosing the P0852 BUICK code

    Labor: 1.0

    The cost of diagnosing the P0852 BUICK code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

P0852 BUICK Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)

P0852 Buick Description

The transmission manual shift shaft switch assembly, also known as the Internal Mode Switch (IMS), is a sliding contact switch attached to the manual shift shaft inside the transmission case. The Park/Neutral Position (PNP) Switch is integrated into the IMS and connects to the Transmission Control Module (TCM) lead-frame through a short wire harness. The 5 inputs to the TCM from the transmission manual shift shaft switch assembly indicate the transmission gear selector lever position. This information is used for engine start enable, engine controls as well as determining the transmission shift patterns. The state of each input is available for display on the scan tool. The five input parameters represented are Signal A, Signal B, Signal C, Signal P (Parity), and Signal N (Park/Neutral Start Signal). Park/Neutral Signal is sent from the Park/Neutral switch directly to the Engine Control Module (ECM) and is used for engine start enable. The Park/Neutral Signal circuit is not connected to the TCM internally; the circuit uses the TCM as a pass-through connector only. The ECM Park/Neutral diagnostic monitors the Park/Neutral Signal circuit to detect Low voltage when the ECM expects to see High voltage and High voltage when the ECM expects to see Low voltage.
OBDII Code P0852 Buick - Park/Neutral Position Switch Circuit High Voltage - AutoCodes.com

P0852 BUICK More Information

Need more information on how to fix the P0852 BUICK code?
Get Access to Factory Service Manuals

Need more help?

Get the P0852 Buick code diagnosed by a professional: Find a repair shop in your area

Related Information

P0852 BUICK Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0852 Buick code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧