AutoCodes.com | All About OBDII Engine Codes
AutoCodes - GMC - P0804 GMC

P0804 GMC Code - Skip Shift Lamp Control Circuit

- Code Popularity: 2,388 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0804 GMC?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Skip Shift Lamp
  • Skip Shift Lamp harness is open or shorted
  • Skip Shift Lamp circuit poor electrical connection
⚠ Does your GMC have Safety Recalls? → Check here

How to Fix the DTC P0804 GMC?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0804 GMC Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0804 GMC code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

When the Powertrain Control Module (PCM) commands the control circuit to a component OFF, the voltage potential of the circuit should be high (near battery voltage). If the fault detection circuit senses a voltage other than what is expected, the fault line status changes causing theP0804 code is set.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0804 GMC Description

An ignition voltage is supplied to the Skip Shift Lamp. The Powertrain Control Module (PCM) controls the lamp by grounding the control circuit via an internal switch called a driver. The driver supplies the ground for the component being controlled. Each driver has a fault line which the PCM monitors. When the PCM commands a component ON, the voltage of the control circuit should be low (near 0 volts).

OBDII Code P0804 GMC - Skip Shift Lamp Control Circuit - AutoCodes.com
P0804 GMC Code - Skip Shift Lamp Control Circuit

Need More Information on the Code?

Need more information on how to fix the P0804 GMC code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0804 GMC code diagnosed by a professional: Find a repair shop in your area

Code P0804 GMC comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0804 GMC code? Have you replaced any parts?
Any information is appreciated. Thanks