AutoCodes - Isuzu - P0741 ISUZU

P0741 ISUZU Code - Torque Converter Clutch System Failure

Repair Importance Level: 3/3
Repair Difficulty Level: 3/3
Table of contents

|P0741 ISUZU code possible causes

  • Low transmission fluid level
  • Dirty transmission fluid
  • Faulty torque converter clutch solenoid valve
  • Torque converter clutch solenoid valve harness or connectors
  • Torque converter clutch solenoid valve circuit is open or shorted
  • Transmission internal mechanical problem

|How do I fix the P0741 ISUZU code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|Cost of diagnosing the P0741 ISUZU code

Labor: 1.0

The cost of diagnosing the P0741 ISUZU code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P0741 ISUZU code detected?

Lock-up does not occur when driving in lock-up range or lockup remains ON in lock-up OFF range

|What are P0741 ISUZU code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

|P0741 ISUZU code description

The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.
OBDII Code P0741 Isuzu - Torque Converter Clutch System Failure - AutoCodes.com

|Need more information with the P0741 ISUZU code?

Need more information on how to fix the P0741 ISUZU code?
Get Access to Factory Service Manuals

|Need help with a P0741 ISUZU code?

Get the P0741 Isuzu code diagnosed by a professional: Find a repair shop in your area

|P0741 ISUZU code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0741 Isuzu code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 3
 
1=Easy 2=Moderate 3=Hard What is this?