AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Audi - P0741 Audi

P0741 Audi Code - Torque Converter Clutch Circuit Performance or Stuck Off

- Code Popularity: 42,535 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0741 Audi?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low transmission fluid level
  • Dirty transmission fluid
  • Faulty torque converter clutch solenoid valve
  • Torque converter clutch solenoid valve harness or connectors
  • Torque converter clutch solenoid valve circuit is open or shorted
  • Transmission internal mechanical problem
⚠ Does your Audi have Safety Recalls? → Check here

How to Fix the DTC P0741 Audi?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0741 Audi Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0741 Audi code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

Lock-up does not occur when driving in lock-up range or lockup remains ON in lock-up OFF range

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0741 Audi Description

The torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.

OBDII Code P0741 Audi - Torque Converter Clutch Circuit Performance or Stuck Off - AutoCodes.com
P0741 Audi Code - Torque Converter Clutch Circuit Performance or Stuck Off

Need More Information on the Code?

Need more information on how to fix the P0741 Audi code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0741 Audi code diagnosed by a professional: Find a repair shop in your area

Code P0741 Audi comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0741 Audi code? Have you replaced any parts?
Any information is appreciated. Thanks