P0740 2006 NISSAN ALTIMA SEDAN Code - Torque Converter Clutch Solenoid Circuit Fault
|P0740 2006 NISSAN ALTIMA SEDAN code possible causes
- Low transmission fluid level
- Dirty transmission fluid
- Faulty torque converter clutch solenoid valve
- Torque converter clutch solenoid valve harness is open or shorted
- Torque converter clutch solenoid valve circuit poor electrical connection
|How do I fix the P0740 2006 NISSAN ALTIMA SEDAN code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|Cost of diagnosing the P0740 2006 NISSAN ALTIMA SEDAN code
Labor: 1.0The cost of diagnosing the P0740 2006 NISSAN ALTIMA SEDAN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0740 2006 NISSAN ALTIMA SEDAN code detected?Diagnostic trouble code P0740 is detected when TCM detects an improper voltage drop when it tries to operate the solenoid valve.
|What are P0740 2006 NISSAN ALTIMA SEDAN code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
- Transmission shift shock
- Vehicle may not shift into the highest gear
|P0740 2006 NISSAN ALTIMA SEDAN code descriptionThe torque converter clutch solenoid valve is activated, with the gear in D4, by the Transmission Control Module (TCM) in response to signals sent from the vehicle speed and the Engine Control Module (ECM). Lock-up piston operation will then be controlled. When the torque converter clutch solenoid valve is activated, the torque converter lockup clutch will engage creating a 1 to 1 RPM ratio between the transmission input shaft and the rotational speed of the torque converter.
Lock-up operation, however, is prohibited when A/T fluid temperature is too low.
When the accelerator pedal is depressed (less than 2/8) in lock-up condition, the engine speed should not change abruptly. If there is a big jump in engine speed, there is no lock-up.
|Need more information with the P0740 2006 NISSAN ALTIMA SEDAN code?Need more information on how to fix the P0740 2006 NISSAN ALTIMA SEDAN code? Get Access to Factory Service Manuals
|Need help with a P0740 2006 NISSAN ALTIMA SEDAN code?Get the P0740 2006 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area
|P0740 2006 NISSAN ALTIMA SEDAN code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0740 2006 Nissan Altima Sedan code? Have you replaced any parts?
Any information is appreciated. Thanks