AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Mitsubishi - P0733 MITSUBISHI

P0733 MITSUBISHI Code - Gear 3 Incorrect Ratio

- Code Popularity: 17,349 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
By AutoCodes.com - Updated Jun 14, 2015
Share on Facebook   Share on Twitter   Share on Linkedin

|P0733 MITSUBISHI code possible causes

  • Low transmission fluid level
  • Dirty transmission fluid
  • Shift solenoids
  • Transmission mechanical problems
  • Transmission hydraulic control circuit

|How do I fix code P0733 MITSUBISHI code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your car have Safety Recalls? → Check here

|P0733 MITSUBISHI code tech notes

Start by inspecting the transmission fluid level and condition, and change fluid if necessary.

|Cost of diagnosing P0733 MITSUBISHI code

Labor: 1.0

The cost of diagnosing the P0733 MITSUBISHI code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|When is the P0733 MITSUBISHI code detected?

P0733 is detected when A/T cannot be shifted to the 3rd gear position even if electrical circuit is good.

|What are P0733 MITSUBISHI code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Incorrect transmission shifting

|P0733 MITSUBISHI code description

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes
If the actual gear position is higher than the position (3rd) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

OBDII Code p0733 mitsubishi - Gear 3 Incorrect Ratio - AutoCodes.com
P0733 MITSUBISHI Code - Gear 3 Incorrect Ratio

|Need more information with the P0733 MITSUBISHI code?

Need more information on how to fix the P0733 MITSUBISHI code? Get Access to Factory Service Manuals

|Need help with a P0733 MITSUBISHI code?

Get the p0733 mitsubishi code diagnosed by a professional: Find a repair shop in your area

|P0733 MITSUBISHI code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the p0733 mitsubishi code? Have you replaced any parts?
Any information is appreciated. Thanks