AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Nissan - P0732 2005 Nissan Altima Sedan

P0732 2005 Nissan Altima Sedan Code - 2nd. Gear Malfunction

- Code Popularity: 5,529 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0732 2005 Nissan Altima Sedan?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low transmission fluid level
  • Dirty transmission fluid
  • Faulty Shift Solenoids
  • Shift Solenoids harness is open or shorted
  • Shift Solenoids circuit poot electrical connection
  • Transmission mechanical problems
  • Transmission hydraulic control circuit
⚠ Does your Nissan have Safety Recalls? → Check here

How to Fix the DTC P0732 2005 Nissan Altima Sedan?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0732 2005 Nissan Altima Sedan Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0732 2005 Nissan Altima Sedan code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

P0732 is detected when A/T cannot be shifted to the 2nd gear position even if electrical circuit is good.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Incorrect transmission shifting

Code P0732 2005 Nissan Altima Sedan Description

This diagnosis monitors actual gear position by checking the torque converter slip ratio calculated by Transmission Control Module (TCM) as follows:
Torque converter slip ratio = A x C/B
A: Output shaft revolution signal from revolution sensor
B: Engine speed signal from Engine Control Module (ECM)
C: Gear ratio determined as gear position which TCM supposes
If the actual gear position is higher than the position (2nd) supposed by TCM, the slip ratio will be more than normal. In case the ratio exceeds the specified value, TCM judges this diagnosis malfunction.

OBDII Code P0732 2005 Nissan Altima Sedan - 2nd. Gear Malfunction - AutoCodes.com
P0732 2005 Nissan Altima Sedan Code - 2nd. Gear Malfunction

Need More Information on the Code?

Need more information on how to fix the P0732 2005 Nissan Altima Sedan code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0732 2005 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area

Code P0732 2005 Nissan Altima Sedan comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0732 2005 Nissan Altima Sedan code? Have you replaced any parts?
Any information is appreciated. Thanks