AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Jeep - P0675 Jeep

P0675 Jeep Code - Cylinder 5 Glow Plug Circuit Fault

- Code Popularity: 1,209 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0675 Jeep?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Cylinder #5 Glow Plug
  • Cylinder #5 Glow Plug harness is open or shorted
  • Cylinder #5 Glow Plug circuit poor electrical connection
  • Faulty Glow Plug Module
⚠ Does your Jeep have Safety Recalls? → Check here

How to Fix the DTC P0675 Jeep?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0675 Jeep Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0675 Jeep code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • The engine may be harder to start
  • Engine hesitation

Code P0675 Jeep Description

The glow plug system is used to assist in providing the heat required to begin combustion during cold engine temperatures. The glow plugs are heated before and during cranking, as well as initial engine operation. The Engine Control Module (ECM) controls the glow plug ON times by monitoring coolant temperature and glow plug voltage. The glow plug system has individual glow plug supply circuits between the controller and the glow plugs. If the feedback voltage from the controller to the ECM is not within range, the ECM sets the OBDII code. The Diagnostic Trouble Code (DTC) will set if the Engine Control Module has detected a fault in the cylinder #5 glow plug circuit.

OBDII Code P0675 Jeep - Cylinder 5 Glow Plug Circuit Fault - AutoCodes.com
P0675 Jeep Code - Cylinder 5 Glow Plug Circuit Fault

Need More Information on the Code?

Need more information on how to fix the P0675 Jeep code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0675 Jeep code diagnosed by a professional: Find a repair shop in your area

Code P0675 Jeep comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0675 Jeep code? Have you replaced any parts?
Any information is appreciated. Thanks