P0675 2015 Chevrolet Silverado Code - Cylinder 5 Glow Plug Circuit Fault
Quick Answer
n the diesel engine, air alone is compressed in the cylinder. Common causes include Faulty cylinder #5 glow plug, Cylinder #5 glow plug harness is open or shorted, Cylinder #5 glow plug circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0675 2015 Chevrolet Silverado indicates Cylinder 5 Glow Plug Circuit Fault.
- Common causes
- Common causes include Faulty cylinder #5 glow plug, Cylinder #5 glow plug harness is open or shorted, Cylinder #5 glow plug circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P0675 2015 Chevrolet Silverado Description
Control of the glow plugs is accomplished by the Glow Plug Control Module. The nominal voltage for the glow plugs is 5.4 volts. When the ignition is turned On, the Glow Plug Control Module applies 7.2 V for 2.2 s, then 5.7 V for 0.8 s, and then 5.4 V until 1200°C (2192°F) is reached. The maximum voltage of the system is 10 V. While the engine is running the voltage will vary between 4.7 - 10 V when in closed loop control to maintain a glow plug temperature that ranges from 1150° - 1180°C (2102° - 2156°F). The temperature and the power consumption are controlled between the Engine Control Module (ECM) and the Glow Plug Control Module within a wide range to suit the engine's pre-heating requirements. Each glow plug is energized individually. This capability yields more optimum heat times for the glow plugs, thus pre - glow times can be kept to a minimum for a short wait to crank times and maximum glow plug durability.
What are the Possible Causes of the DTC P0675 2015 Chevrolet Silverado?
- Faulty cylinder #5 glow plug
- Cylinder #5 glow plug harness is open or shorted
- Cylinder #5 glow plug circuit poor electrical connection
- Faulty Glow Plug Control Module (GPCM)
How to Fix the DTC P0675 2015 Chevrolet Silverado?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0675 2015 Chevrolet Silverado code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0675 2015 Chevrolet Silverado code?
Need more information on how to fix the P0675 2015 Chevrolet Silverado code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0675 2015 Chevrolet Silverado code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0675 2015 Chevrolet Silverado Code
What does code P0675 mean on a 2015 Chevrolet Silverado?
Code P0675 indicates a Cylinder 5 Glow Plug Circuit Fault, meaning the glow plug for cylinder 5 is not functioning properly or there is an issue in its electrical circuit.
What are the symptoms of a P0675 code?
Symptoms may include difficulty starting the engine, rough idle in cold conditions, increased exhaust smoke, or an illuminated check engine light.
What causes the P0675 code?
Common causes include a faulty glow plug, damaged wiring or connectors in the glow plug circuit, a malfunctioning glow plug control module, or corrosion in the electrical components.
Can I drive my 2015 Silverado with a P0675 code?
While the truck may still run, driving with this code can lead to hard starting in cold weather and potential damage to other engine components over time. It’s best to address the issue sooner rather than later.
How do I diagnose a P0675 code?
Start by visually inspecting the glow plug for cylinder 5, checking the wiring and connectors for damage or corrosion, and testing the glow plug for proper resistance using a multimeter.
How do I fix a P0675 code?
Repair steps may include replacing the glow plug, repairing or replacing damaged wiring or connectors, or replacing the glow plug control module if it’s faulty.
What is the cost to fix a P0675 code?
Repair costs vary but typically range from $50 to $150 for a glow plug replacement, not including labor, which can add another $50 to $200 depending on the shop.
How can I prevent the P0675 code from recurring?
Regular maintenance, including inspecting glow plugs and their wiring for damage or corrosion, can help prevent this code from reappearing.
Do I need special tools to fix a P0675 code?
You may need basic tools like a multimeter to test electrical components and standard hand tools to replace the glow plug or repair wiring.
Can a P0675 code cause other problems?
Yes, unresolved glow plug issues can lead to poor engine performance, reduced fuel efficiency, increased emissions, and difficulty starting the vehicle in cold weather.
Discuss the causes and fixes for P0675 2015 Chevrolet Silverado OBDII Code
Code P0675 2015 Chevrolet Silverado comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
