AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - P0607 2008 Toyota Camry

P0607 2008 Toyota Camry Code - Control Module Performance

- Code Popularity: 2,536 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0607 2008 Toyota Camry?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Exhaust Leak
  • Oxygen Sensor
  • Faulty Engine Control Module (ECM)
  • Engine Control Module (ECM) Harness power supply circuit is open or shorted
  • Engine Control Module (ECM) Programming
⚠ Does your Toyota have Safety Recalls? → Check here

How to Fix the DTC P0607 2008 Toyota Camry?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Check for Exhaust leaks, oxygen sensor and ECM fuse, if fuse is OK try erasing the code first and if the code comes back you may have to reprogram or replaced the ECM.

Search for P0607 2008 Toyota Camry Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0607 2008 Toyota Camry code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

Indicates the ECM has experienced an internal memory fault.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine may not start

Code P0607 2008 Toyota Camry Description

The Engine Control Module (ECM) continuously monitors its internal memory status, internal circuits, and output signals to the throttle actuator. This self−check insures that the ECM is functioning properly. If any malfunction is detected, the ECM will set the code and illuminate the engine light.
The ECM memory status is diagnosed by internal mirroring of the main CPU and the sub CPU to detect Random Access Memory (RAM) errors. The two CPUs also perform continuous mutual monitoring. The ECM illuminates the MIL and sets a DTC if: 1) outputs from the two CPUs are different or deviate from the standards, 2) the signals sent to the throttle actuator deviate from the standards, 3) a malfunction is found in the throttle actuator supply voltage, and 4) any other ECM malfunction is found.
OBDII Code P0607 2008 Toyota Camry - Control Module Performance - AutoCodes.com
P0607 2008 Toyota Camry Code - Control Module Performance

Need More Information on the Code?

Need more information on how to fix the P0607 2008 Toyota Camry code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0607 2008 Toyota Camry code diagnosed by a professional: Find a repair shop in your area

Code P0607 2008 Toyota Camry comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0607 2008 Toyota Camry code? Have you replaced any parts?
Any information is appreciated. Thanks