AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Honda - P0560 Honda

P0560 Honda Code - ECM Power Source Circuit Unexpected Voltage

- Code Popularity: 20,111 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0560 Honda?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Low battery charge
  • Battery defective
  • Loose or missing alternator drive belt
  • Faulty alternator
  • Open or short system voltage circuit
⚠ Does your Honda have Safety Recalls? → Check here

How to Fix the DTC P0560 Honda?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Start by recharging or replacing the battery.

Search for P0560 Honda Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0560 Honda code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The P0560 code is detected when the Engine Control Module (ECM) voltage out of range.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Slow engine start
  • Low battery power

Code P0560 Honda Description

The battery supplies electricity to the Engine Control Module (ECM) even when the ignition switch is OFF. This electricity allows the ECM to store data such as Diagnostic Trouble Code (DTC) history, freeze frame data, fuel trim values and other data. If the battery voltage falls below a minimum level, the ECM will conclude that there is a fault in the power supply circuit. The next time the engine starts, the ECM will turn on the Malfunction Indicator Light (MIL) and a DTC will be set.

OBDII Code P0560 Honda - ECM Power Source Circuit Unexpected Voltage - AutoCodes.com
P0560 Honda Code - ECM Power Source Circuit Unexpected Voltage

Need More Information on the Code?

Need more information on how to fix the P0560 Honda code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0560 Honda code diagnosed by a professional: Find a repair shop in your area

Code P0560 Honda comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0560 Honda code? Have you replaced any parts?
Any information is appreciated. Thanks