AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Jeep - P0541 Jeep

P0541 Jeep Code - Intake Air Heater 'A' Circuit Low

- Code Popularity: 3,595 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0541 Jeep?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Intake Air Heater (IAH) Relay
  • Faulty Intake Air Heater
  • Intake Air Heater Relay harness is open or shorted
  • Intake Air Heater Relay circuit poor electrical connection
  • Intake Air Heater harness is open or shorted
  • Intake Air Heater circuit poor electrical connection
⚠ Does your Jeep have Safety Recalls? → Check here

How to Fix the DTC P0541 Jeep?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0541 Jeep Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0541 Jeep code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The Engine Control Module (ECM) sends a bias voltage on diagnostic circuits one and two. If this voltage is not pulled low when the relay is OFF DTC P0541 will set. The ECM will only store info on first failure, It triggers the SES light on the second failure.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0541 Jeep Description

The Engine Control Module (ECM) uses an Intake Air Heater (IAH) to warm the incoming air for proper cylinder combustion. The ECM grounds the control coil of the IAH relay to energize the heater during cold operation. The control module will command the IAH ON when the engine coolant temperature is below 40 C (104 F). The power to the IAH heater is supplied by the battery positive voltage circuit through the IAH relay.

OBDII Code P0541 Jeep - Intake Air Heater 'A' Circuit Low - AutoCodes.com
P0541 Jeep Code - Intake Air Heater 'A' Circuit Low

Need More Information on the Code?

Need more information on how to fix the P0541 Jeep code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0541 Jeep code diagnosed by a professional: Find a repair shop in your area

Code P0541 Jeep comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0541 Jeep code? Have you replaced any parts?
Any information is appreciated. Thanks