P0524 Dodge Code - Engine Oil Pressure Sensor/Switch Circuit
Quick Answer
For the Multi-Displacement System (MDS) to enable the 4-cylinder mode, the oil pressure must be approximately 25 psi. Common causes include Low oil level or motor mechanical fault, Faulty Oil Pressure sensor, Oil Pressure Sensor harness is open or shorted. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0524 Dodge indicates Engine Oil Pressure Sensor/Switch Circuit.
- Common causes
- Common causes include Low oil level or motor mechanical fault, Faulty Oil Pressure sensor, Oil Pressure Sensor harness is open or shorted.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P0524 Dodge Description
What are the Possible Causes of the DTC P0524 Dodge?
- Low oil level or motor mechanical fault
- Faulty Oil Pressure sensor
- Oil Pressure Sensor harness is open or shorted
- Oil Pressure Sensor circuit poor electrical connection
How to Fix the DTC P0524 Dodge?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0524 Dodge code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0524 Dodge code?
Need more information on how to fix the P0524 Dodge code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0524 Dodge code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0524 Dodge Code
No Frequently Asked Questions about P0524 Dodge Code found.
Discuss the causes and fixes for P0524 Dodge OBDII Code
-
WHERE IS THIS SENSOR LOCATED FOR P0524 CODE? I HAVE A 2007 5.7 RAM 1500 AND WHERE IS THE CAM POSITION SENSOR LOCATED FOR CODE P0344
-
-
On your 2007 Dodge Charger R/T with the 5.7L HEMI, the engine oil pressure sensor is located at the rear of the engine block, just above the oil filter housing and below the intake manifold.
Here's how to find it:
- Look from the passenger side, near the back of the engine, behind the intake.
- It screws into the oil passage at the top-rear of the engine, slightly tilted.
- You'll need to remove the engine cover and may need a long extension and oil pressure switch socket to reach it.
If you're replacing it, make sure to use a quality part—cheap sensors are known to fail prematurely on these engines. Also, check the connector for oil contamination, as the sensors can leak internally.
Let me know if you need torque specs or part number tips.
-
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
