P0505 HONDA Possible Causes
- Faulty Idle Air Control Valve (IACV) valve
- IAC valve harness is open or shorted
- IAC valve circuit poor electrical connection
First diagnose P0505 HONDA code
Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
P0505 HONDA Tech NotesThe problem is very common with Honda Civic and Honda Accord vehicles, and adjusting the engine idle speed usually takes care of the problem, also there is a service bulletin for the following Honda models:
2001 and 2003 Honda Odyssey
2003 Honda Pilot
Factory Service Bulletin OBDII Code P0505
Cost of diagnosing the P0505 HONDA code
Labor: 1.0The cost of diagnosing the P0505 HONDA code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.
When is the P0505 HONDA code detected?The P0505 code is set when the IACV-AAC valve does not operate properly.
P0505 HONDA Possible Symptoms
- Engine Light ON (or Service Engine Soon Warning Light)
- Engine hard to start
- Rough or erratic idle speed
P0505 Honda DescriptionThis system automatically controls engine idle speed to a specified level. Idle speed is controlled through fine adjustment of the amount of air which by-passes the throttle valve via Idle Air Control Valve (IACV) and Auxiliary Air Control AAC) Valve. The IACV-AAC valve changes the opening of the air by-pass passage to control the amount of auxiliary air. This valve is actuated by a step motor built into the valve, which moves the valve in the axial direction in steps corresponding to the Engine Control Module (ECM) output signals.
One step of IACV-AAC valve movement causes the respective opening of the air by-pass passage. (i.e. when the step advances, the opening is enlarged.) The opening of the valve is varied to allow for optimum control of the engine idling speed. The crankshaft position sensor (POS) detects the actual engine speed and sends a signal to the ECM. The ECM then controls the step position of the IACV-AAC valve so that engine speed coincides with the target value memorized in ECM. The target engine speed is the lowest speed at which the engine can operate steadily. The optimum value stored in the ECM is determined by taking into consideration various engine conditions, such as during warm-up, deceleration, and engine load (air conditioner, power steering, and cooling fan operation).
P0505 HONDA More InformationNeed more information on how to fix the P0505 HONDA code?
Get Access to Factory Service Manuals
P0505 Honda Information for specific Honda models
Need more help?Get the P0505 Honda code diagnosed by a professional: Find a repair shop in your area
P0505 HONDA CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0505 Honda code? Have you replaced any parts?
Any information is appreciated. Thanks