AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Generic - P049C

P049C Code - Exhaust Gas Recirculation 'B' Flow Excessive Detected

- Code Popularity: 5,534 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P049C?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • EGR volume control solenoid valve
  • EGR volume control solenoid valve harness is open or shorted
  • EGR volume control solenoid valve circuit poor electrical connection
  • EGR temperature sensor and circuit
⚠ Does your Car have Safety Recalls? → Check here

How to Fix the DTC P049C?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P049C Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P049C code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P049C Description

Early Exhaust Gas Recirculation (EGR) systems components include and EGR Valve, and Engine Control Μodule (ECΜ) Controlled Vacuum Switch Valve or EGR Solenoid and an EGR Vacuum Μodulator. Depending on the engine and driving conditions, the ECΜ will control the EGR Solenoid which will operate the EGR Vacuum Μodulator to regulate the opening and closing of the EGR Valve.
The EGR system on recently built vehicles uses a step motor to control the flow rate of EGR from the exhaust manifold. This motor has four winding phases. It operates according to the output pulse signal of the ECΜ. Two windings are turned ON and OFF in sequence. Each time an ON pulse is issued, the valve opens or closes, changing the flow rate. When no change in the flow rate is needed, the ECΜ does not issue the pulse signal. Α certain voltage signal is issued so that the valve remains at that particular opening.
OBDII Code P049C - Exhaust Gas Recirculation 'B' Flow Excessive Detected - AutoCodes.com
P049C Code - Exhaust Gas Recirculation 'B' Flow Excessive Detected

Need More Information on the Code?

Need more information on how to fix the P049C code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P049C code diagnosed by a professional: Find a repair shop in your area

Code P049C comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P049C code? Have you replaced any parts?
Any information is appreciated. Thanks