AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Audi - P048A Audi

P048A Audi Code - Exhaust Pressure Control Valve 'A' Stuck Closed

- Code Popularity: 1,983 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P048A Audi?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Exhaust Back Pressure Valve
  • Exhaust Back Pressure Valve harness is open or shorted
  • Exhaust Back Pressure Valve circuit poor electrical connection
⚠ Does your Audi have Safety Recalls? → Check here

How to Fix the DTC P048A Audi?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P048A Audi Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P048A Audi code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P048A Audi Description

Exhaust Back Pressure Regulator - Is a variable position valve that controls exhaust back pressure during cold ambient temperatures to increase cab heat and decrease the amount of time needed to defrost the windshield. The Engine Control Module (ECM) uses the measured exhaust back pressure, (ambient) intake air temperature, engine oil temperature and engine load to determine the desired exhaust back pressure. Valve position is controlled by switching the output signal circuit to 12 volts inside the ECM. On/off time is modulated from 0 to 99 % dependent upon the exhaust back pressure desired.
Upon each initial engine start-up, the ECM exercises the exhaust back pressure valve by commanding it to cycle on and off once. If upon start-up the temperature of intake air sensed by the Intake Air Temperature (IAT) sensor is < 37°F (5°C) and the oil temperature sensed by the Engine Oil Temperature (EOT) sensor is between 32°-140°F (0-60°C) it will continue to keep the back pressure valve partially closed. As the oil temperature rises during engine operation, the ECM will control the valve in response to the rising oil temperature.

OBDII Code P048A Audi - Exhaust Pressure Control Valve 'A' Stuck Closed - AutoCodes.com
P048A Audi Code - Exhaust Pressure Control Valve 'A' Stuck Closed

Need More Information on the Code?

Need more information on how to fix the P048A Audi code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P048A Audi code diagnosed by a professional: Find a repair shop in your area

Code P048A Audi comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P048A Audi code? Have you replaced any parts?
Any information is appreciated. Thanks