AutoCodes – Jeep – P0477 Jeep

P0477 Jeep Code - Low Voltage On The Engine Brake Driver

Quick Answer

Exhaust Back Pressure Regulator - Is a variable position valve that controls exhaust back pressure during cold ambient temperatures to increase cab heat and decrease the amount of time needed to defrost the windshield. Common causes include Faulty Engine Brake Driver Relay, Engine Brake Driver harness is open or shorted, Engine Brake Driver circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

What it means: P0477 Jeep indicates Low Voltage On The Engine Brake Driver.
Common causes: Common causes include Faulty Engine Brake Driver Relay, Engine Brake Driver harness is open or shorted, Engine Brake Driver circuit poor electrical connection.
Severity: Moderate - service should be scheduled soon.
Can I drive?: The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.

Save to My Repairs My Repairs

AI answers can be wrong. Verify repairs with testing. Open full chat

Code Popularity 2,981

How popular is this code, among other codes? Low

Repair Importance Level

Moderate (Service soon) (2 / 3)

Repair Difficulty Level

Advanced (Pro) (3 / 3)

What is this?

Table of contents Created and updated by William Orellana on Apr 24, 2019

Description
Possible Causes
How To Fix
Cost to Diagnose
Comments
Add Comment

💬 Need more help? Ask Coddy for instant answers — it's free!

Code P0477 Jeep Description

Exhaust Back Pressure Regulator - Is a variable position valve that controls exhaust back pressure during cold ambient temperatures to increase cab heat and decrease the amount of time needed to defrost the windshield. The Engine Control Module (ECM) uses the measured exhaust back pressure, (ambient) intake air temperature, engine oil temperature and engine load to determine the desired exhaust back pressure. Valve position is controlled by switching the output signal circuit to 12 volts inside the ECM. On/off time is modulated from 0 to 99 % dependent upon the exhaust back pressure desired.
Upon each initial engine start-up, the ECM exercises the exhaust back pressure valve by commanding it to cycle on and off once. If upon start-up the temperature of intake air sensed by the Intake Air Temperature (IAT) sensor is < 37°F (5°C) and the oil temperature sensed by the Engine Oil Temperature (EOT) sensor is between 32°-140°F (0-60°C) it will continue to keep the back pressure valve partially closed. As the oil temperature rises during engine operation, the ECM will control the valve in response to the rising oil temperature.

OBDII Code P0477 Jeep - Low Voltage On The Engine Brake Driver - AutoCodes.com — P0477 Jeep Code - Low Voltage On The Engine Brake Driver

What does this mean?

What are the Possible Causes of the DTC P0477 Jeep?

Faulty Engine Brake Driver Relay
Engine Brake Driver harness is open or shorted
Engine Brake Driver circuit poor electrical connection

How to Fix the DTC P0477 Jeep?

Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0477 Jeep code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.

Need more information about the P0477 Jeep code?

Need more information on how to fix the P0477 Jeep code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0477 Jeep code diagnosed by a professional: Find a repair shop in your area

About the author: William Orellana is a Master Mechanic and Mechanical Engineer with over 30 years of experience diagnosing and repairing vehicles. Learn more about his background.