AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0452 2010 Ford Fusion

P0452 2010 Ford Fusion Code - EVAP Pressure Sensor/Switch Low

- Code Popularity: 3,268 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0452 2010 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty Fuel Tank Pressure Sensor
  • Fuel Tank Pressure Sensor Harness is Open or Shorted
  • Fuel Tank Pressure Sensor Circuit Poor Electrical Connection
  • Faulty Engine Control Module (ECM)
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0452 2010 Ford Fusion?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Search for P0452 2010 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0452 2010 Ford Fusion code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

An excessively low voltage from the sensor is sent to Engine Control Module (ECM).

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)

Code P0452 2010 Ford Fusion Description

The Powertrain Control Module (PCM) monitors the evaporative emission (EVAP) control system fuel tank pressure (FTP) sensor input signal to the PCM. The test fails when the signal average drops below a minimum allowable calibrated parameter.

OBDII Code P0452 2010 Ford Fusion - EVAP Pressure Sensor/Switch Low - AutoCodes.com
P0452 2010 Ford Fusion Code - EVAP Pressure Sensor/Switch Low

Need More Information on the Code?

Need more information on how to fix the P0452 2010 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0452 2010 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Code P0452 2010 Ford Fusion comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0452 2010 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks