P0448 SUBARU - Evaporative Emission Control System Vent Control Circuit Close
- Faulty canister vent control valve
- Purge Control Valve harness is open or shorted
- Purge Control Valve electrical circuit poor connection
When is the code detected?EVAP canister vent control valve remains closed under specified driving conditions.
- Engine Light ON (or Service Engine Soon Warning Light)
P0448 Subaru DescriptionThe Evaporative Emission System (EVAP) canister vent control valve is located on the EVAP canister and is used to seal the canister vent. This solenoid (the EVAP canister vent control valve) responds to signals from the Engine Control Module (ECM). When the ECM sends an ON signal, the coil in the solenoid valve is energized.
A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system componentsThis solenoid valve is used only for diagnosis, and usually remains opened. When the vent is closed, under normal purge conditions, the evaporative emission control system is depressurized and allows EVAP Control System (Small Leak) diagnosis.
Need more help?Get the P0448 Subaru code diagnosed by a professional: Find a repair shop in your area
P0448 SUBARU CommentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0448 Subaru code? Have you replaced any parts?
Any information is appreciated. Thanks