AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Ford - P0446 2010 Ford Fusion

P0446 2010 Ford Fusion Code - EVAP System Vent Control Circuit

- Code Popularity: 7,942 Views
- Repair Importance Level: 1/3
- Repair Difficulty Level: 3/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0446 2010 Ford Fusion?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Missing Fuel cap
  • Incorrect fuel filler cap used
  • Fuel filler cap remains open or fails to close
  • Foreign matter caught in fuel filler cap
  • Vent control valve harness is open or shorted
  • Vent control valve circuit poor electrical connection
  • Faulty vent control valve
⚠ Does your Ford have Safety Recalls? → Check here

How to Fix the DTC P0446 2010 Ford Fusion?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Before replacing any parts, try re-tighten the gas cap and clearing the code. If the cap or cap seal is damage replaced cap and clear the code.

Search for P0446 2010 Ford Fusion Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0446 2010 Ford Fusion code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

- The P0446 codes triggered when an improper voltage signal is sent to ECM through EVAP canister vent control valve.

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • A noticeable fuel odor may result from fuel vapor release

Code P0446 2010 Ford Fusion Description

The Evaporative System (EVAP) canister vent control valve is located on the EVAP canister and is used to seal the canister vent.
This solenoid valve responds to signals from the Engine Control Module (ECM). When the ECM sends an ON signal, the coil in the solenoid valve is energized. A plunger will then move to seal the canister vent. The ability to seal the vent is necessary for the on board diagnosis of other evaporative emission control system components.
This solenoid valve is used only for diagnosis, and usually remains opened.

OBDII Code P0446 2010 Ford Fusion - EVAP System Vent Control Circuit  - AutoCodes.com
P0446 2010 Ford Fusion Code - EVAP System Vent Control Circuit

Need More Information on the Code?

Need more information on how to fix the P0446 2010 Ford Fusion code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0446 2010 Ford Fusion code diagnosed by a professional: Find a repair shop in your area

Code P0446 2010 Ford Fusion comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0446 2010 Ford Fusion code? Have you replaced any parts?
Any information is appreciated. Thanks