P0443 2008 Nissan Rogue Code - EVAP Canister Purge Volume Control Solenoid Valve
Quick Answer
This system controls the flow rate of fuel vapor from the EVAP canister. Common causes include Faulty EVAP Canister Purge Volume Control Solenoid Valve, EVAP Canister Purge Volume Control Solenoid Valve harness is open or shorted, EVAP Canister Purge Volume Control Solenoid Valve circuit poor electrical connection. Severity is Low - monitor the vehicle and repair when practical. The vehicle can usually be driven if no severe symptoms are present, but symptoms should be checked before extended driving.
- What it means
- P0443 2008 Nissan Rogue indicates EVAP Canister Purge Volume Control Solenoid Valve.
- Common causes
- Common causes include Faulty EVAP Canister Purge Volume Control Solenoid Valve, EVAP Canister Purge Volume Control Solenoid Valve harness is open or shorted, EVAP Canister Purge Volume Control Solenoid Valve circuit poor electrical connection.
- Severity
- Low - monitor the vehicle and repair when practical.
- Can I drive?
- The vehicle can usually be driven if no severe symptoms are present, but symptoms should be checked before extended driving.
Code P0443 2008 Nissan Rogue Description
The EVAP canister purge volume control solenoid valve uses an ON/OFF duty to control the flow rate of fuel vapor from the EVAP canister. The EVAP canister purge volume control solenoid valve is moved by ON/OFF pulses from the ECM. The longer the ON pulse, the greater the amount of fuel vapor that will flow through the valve.
The Diagnostic Trouble Code (DTC) will set when the canister purge flow is detected during the specified driving conditions, even when the EVAP canister purge volume control solenoid valve is completely closed.
What are the Possible Causes of the DTC P0443 2008 Nissan Rogue?
- Faulty EVAP Canister Purge Volume Control Solenoid Valve
- EVAP Canister Purge Volume Control Solenoid Valve harness is open or shorted
- EVAP Canister Purge Volume Control Solenoid Valve circuit poor electrical connection
- Faulty EVAP Control System Pressure Sensor
How to Fix the DTC P0443 2008 Nissan Rogue?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0443 2008 Nissan Rogue code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0443 2008 Nissan Rogue code?
Need more information on how to fix the P0443 2008 Nissan Rogue code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0443 2008 Nissan Rogue code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0443 2008 Nissan Rogue Code
1. What does the OBDII code P0443 mean on a 2008 Nissan Rogue?
P0443 indicates a malfunction in the EVAP Canister Purge Volume Control Solenoid Valve circuit, which is part of the vehicle's evaporative emissions system.
2. What are the common symptoms of code P0443 on a 2008 Nissan Rogue?
Typical symptoms include an illuminated check engine light, potential fuel odor, and possible minor decreases in fuel efficiency. No noticeable performance issues are often reported.
3. What causes the P0443 code on a 2008 Nissan Rogue?
Possible causes include a faulty purge control solenoid valve, damaged wiring or connectors, or an open/short circuit in the solenoid valve circuit.
4. Can I drive my 2008 Nissan Rogue with the P0443 code?
Yes, the car is generally drivable with this code, but it may fail an emissions test and could lead to long-term emissions system damage if not repaired.
5. How do I diagnose the P0443 code on my 2008 Nissan Rogue?
Start by visually inspecting the purge solenoid valve, wiring, and connectors for damage. Use a multimeter to check for proper voltage and continuity in the solenoid circuit.
6. How can I fix the P0443 code on a 2008 Nissan Rogue?
Repairs may include replacing the EVAP canister purge solenoid valve, repairing damaged wiring, or cleaning corroded electrical connections.
7. Where is the EVAP canister purge solenoid valve located on a 2008 Nissan Rogue?
The purge solenoid valve is typically located near the engine, attached to the intake manifold or close to the firewall.
8. How much does it cost to repair a P0443 code on a 2008 Nissan Rogue?
The cost to replace the purge solenoid valve ranges from $100 to $300, depending on labor rates and part prices.
9. Can a loose gas cap cause the P0443 code on a 2008 Nissan Rogue?
No, a loose gas cap is more likely to trigger a different EVAP-related code, such as P0455 or P0442.
10. Will clearing the P0443 code fix the issue permanently?
No, clearing the code with a scan tool will only reset the check engine light temporarily. The underlying issue must be addressed to prevent the code from returning.
Discuss the causes and fixes for P0443 2008 Nissan Rogue OBDII Code
Code P0443 2008 Nissan Rogue comments
No comments found for this page.
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
