P0403 2004 Nissan Maxima Code - Exhaust Gas Recirculation Volume Control Valve Circuit
Quick Answer
Early Exhaust Gas Recirculation (EGR) systems component s include and EGR Valve, and Engine Control Μodule (ECΜ) Controlled Vacuum Switch Valve or EGR Solenoid and an EGR Vacuum Μodulator. Common causes include Faulty EGR volume control solenoid valve, EGR volume control solenoid valve harness is open or shorted, EGR volume control solenoid valve circuit poor electrical connection. Severity is Moderate - service should be scheduled soon. The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
- What it means
- P0403 2004 Nissan Maxima indicates Exhaust Gas Recirculation Volume Control Valve Circuit.
- Common causes
- Common causes include Faulty EGR volume control solenoid valve, EGR volume control solenoid valve harness is open or shorted, EGR volume control solenoid valve circuit poor electrical connection.
- Severity
- Moderate - service should be scheduled soon.
- Can I drive?
- The vehicle may still be drivable for short trips if it runs normally, but avoid hard driving and repair it soon.
Code P0403 2004 Nissan Maxima Description
The EGR system on recently built vehicles uses a step motor to control the flow rate of EGR from exhaust manifold. This motor has four winding phases. It operates according to the output pulse signal of the ECΜ. Two windings are turned ON and OFF in sequence. Each time an ON pulse is issued, the valve opens or closes, changing the flow rate. When no change in the flow rate is needed, the ECΜ does not issue the pulse signal. Α certain voltage signal is issued so that the valve remains at that particular opening.
What are the Possible Causes of the DTC P0403 2004 Nissan Maxima?
- Faulty EGR volume control solenoid valve
- EGR volume control solenoid valve harness is open or shorted
- EGR volume control solenoid valve circuit poor electrical connection
- EGR temperature sensor and circuit
How to Fix the DTC P0403 2004 Nissan Maxima?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0403 2004 Nissan Maxima code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0403 2004 Nissan Maxima code?
Need more information on how to fix the P0403 2004 Nissan Maxima code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0403 2004 Nissan Maxima code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0403 2004 Nissan Maxima Code
1. What are the common symptoms of OBDII code P0403 on a 2004 Nissan Maxima?
The common symptoms of code P0403 include rough idling, decreased fuel efficiency, engine stalling, and the illumination of the Check Engine Light.
2. What does the OBDII code P0403 indicate on a 2004 Nissan Maxima?
Code P0403 indicates a potential issue with the Exhaust Gas Recirculation (EGR) Volume Control Valve Circuit in the 2004 Nissan Maxima.
3. What are the possible causes of OBDII code P0403 on a 2004 Nissan Maxima?
Possible causes of code P0403 include a faulty EGR volume control valve, a damaged EGR valve position sensor, wiring issues, or a failed EGR system.
4. How can I diagnose the cause of OBDII code P0403 on my 2004 Nissan Maxima?
Diagnosing code P0403 typically involves inspecting the EGR valve and its components, checking for wiring faults, testing the EGR valve position sensor, and using a scan tool to monitor EGR system data.
5. Can I still drive my 2004 Nissan Maxima with OBDII code P0403 present?
It is not recommended to drive your vehicle with code P0403 active, as it can lead to poor engine performance and potential damage to other components over time.
6. How can I repair OBDII code P0403 on a 2004 Nissan Maxima?
Repairing code P0403 may involve replacing the EGR volume control valve, repairing or replacing damaged wiring, resetting the EGR system, or addressing any underlying issues causing the fault.
7. Can a dirty EGR system cause OBDII code P0403 on a 2004 Nissan Maxima?
Yes, a dirty or clogged EGR system can restrict the flow of exhaust gases, leading to code P0403 on a 2004 Nissan Maxima.
8. How much does it cost to fix OBDII code P0403 on a 2004 Nissan Maxima?
The cost of fixing code P0403 can vary depending on the exact cause of the issue, but it may range from $100 to $500 for parts and labor.
9. Will resetting the Check Engine Light resolve OBDII code P0403 on a 2004 Nissan Maxima?
Resetting the Check Engine Light may temporarily turn off the light, but it will not fix the underlying issue causing code P0403. It is important to diagnose and repair the problem to prevent further issues.
10. Is OBDII code P0403 a common problem in 2004 Nissan Maxima vehicles?
While not extremely common, code P0403 can occur in 2004 Nissan Maxima vehicles due to issues with the EGR system components. Regular maintenance and inspections can help prevent this code from appearing.
Discuss the causes and fixes for P0403 2004 Nissan Maxima OBDII Code
-
On a 2004 Maxima what does a 403 code means and what are the powers involved
-
The P0403 code means that there is a problem with the EGR volume control solenoid valve or the wires from the valve to the Engine Control Module (ECM)
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
