P0400 FORD - Exhaust Gas Recirculation Flow

Repair Importance Level: 2/3
Repair Difficulty Level: 2/3   
Comments  |  Add Comment

P0400 FORD Possible Causes

  • Exhaust Gas Recirculation (EGR) volume control valve stuck closed
  • Faulty Exhaust Gas Recirculation (EGR) volume control solenoid valve
  • Faulty EGR Valve
  • Faulty EGR temperature sensor and circuit
  • Exhaust Gas Recirculation (EGR) solenoid valve harness is open or shorted
  • Exhaust Gas Recirculation (EGR) solenoid valve circuit poor electrical connection
  • Dead (Weak) battery

First diagnose P0400 FORD code

    Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded terminals.

P0400 FORD Tech Notes

EGR flow malfunction could be caused by a clogged EGR valve or EGR tube. Before replacing any parts try cleaning the EGR valve, tube and passages.

Cost of diagnosing the P0400 FORD code

    Labor: 1.0

    The cost of diagnosing the P0400 FORD code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

When is the P0400 FORD code detected?

Exhaust Gas Recirculation (EGR) flow control is not responding

P0400 FORD Possible Symptoms

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Possible engine hesitation

P0400 Ford Description

Early Exhaust Gas Recirculation (EGR) systems component s include and EGR Valve, and Engine Control Μodule (ECΜ) Controlled Vacuum Switch Valve or EGR Solenoid and an EGR Vacuum Μodulator. Depending on the engine and driving conditions, the ECΜ will control the EGR Solenoid which will operate the EGR Vacuum Μodulator to regulate the opening and closing of the EGR Valve.

The EGR system on recently built vehicles uses a step motor to control the flow rate of EGR from exhaust manifold. This motor has four winding phases. It operates according to the output pulse signal of the ECΜ. Two windings are turned ON and OFF in sequence. Each time an ON pulse is issued, the valve opens or closes, changing the flow rate. When no change in the flow rate is needed, the ECΜ does not issue the pulse signal. Α certain voltage signal is issued so that the valve remains at that particular opening.

OBDII Code P0400 Ford - Exhaust Gas Recirculation Flow - AutoCodes.com

P0400 FORD More Information

Need more information on how to fix the P0400 FORD code?
Get Access to Factory Service Manuals

Need more help?

Get the P0400 Ford code diagnosed by a professional: Find a repair shop in your area

Related Information

P0400 FORD Comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above help you fix the code. What are the symptoms on your vehicle for the P0400 Ford code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧