P0400 DODGE Code - Exhaust Gas Recirculation System Performance
|P0400 DODGE code possible causes
- Exhaust Gas Recirculation (EGR) volume control valve stuck closed
- Faulty Exhaust Gas Recirculation (EGR) volume control solenoid valve
- Faulty EGR Valve
- Faulty EGR temperature sensor and circuit
- Exhaust Gas Recirculation (EGR) solenoid valve harness is open or shorted
- Exhaust Gas Recirculation (EGR) solenoid valve circuit poor electrical connection
- Dead (Weak) battery
|How do I fix the P0400 DODGE code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|P0400 DODGE code tech notesEGR flow malfunction could be caused by a clogged EGR valve or EGR tube. Before replacing any parts try cleaning the EGR valve, tube and passages.
|Cost of diagnosing the P0400 DODGE code
Labor: 1.0The cost of diagnosing the P0400 DODGE code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0400 DODGE code detected?Exhaust Gas Recirculation (EGR) flow control is not responding
|What are P0400 DODGE code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible engine hesitation
|P0400 DODGE code descriptionEarly Exhaust Gas Recirculation (EGR) systems component s include and EGR Valve, and Engine Control Μodule (ECΜ) Controlled Vacuum Switch Valve or EGR Solenoid and an EGR Vacuum Μodulator. Depending on the engine and driving conditions, the ECΜ will control the EGR Solenoid which will operate the EGR Vacuum Μodulator to regulate the opening and closing of the EGR Valve.
The EGR system on recently built vehicles uses a step motor to control the flow rate of EGR from exhaust manifold. This motor has four winding phases. It operates according to the output pulse signal of the ECΜ. Two windings are turned ON and OFF in sequence. Each time an ON pulse is issued, the valve opens or closes, changing the flow rate. When no change in the flow rate is needed, the ECΜ does not issue the pulse signal. Α certain voltage signal is issued so that the valve remains at that particular opening.
|Need more information with the P0400 DODGE code?Need more information on how to fix the P0400 DODGE code? Get Access to Factory Service Manuals
|Need help with a P0400 DODGE code?Get the P0400 Dodge code diagnosed by a professional: Find a repair shop in your area
|P0400 DODGE code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0400 Dodge code? Have you replaced any parts?
Any information is appreciated. Thanks