P0366 2016 Honda CR-V Code - Camshaft Position Sensor 'B' and Crankshaft Position Sensor Incorrect Phase Detected

P0366 indicates that the vehicle's engine control module (ECM) has detected an incorrect phase relationship between the camshaft position sensor 'B' and the crankshaft position sensor.

Common symptoms include the Check Engine Light turning on, poor engine performance, rough idling, difficulty starting the engine, or stalling.

Potential causes include a faulty camshaft position sensor 'B', damaged or misaligned timing components, poor electrical connections, a bad crankshaft position sensor, or issues with the ECM.

It’s not recommended to drive with this code active, as it can lead to poor performance, stalling, or further engine damage if left unaddressed.

Start by inspecting the camshaft position sensor 'B' and its wiring for damage or poor connections. Check the timing components and use a diagnostic scanner to verify the sensor readings.

Repairs may involve replacing the camshaft position sensor 'B', repairing or replacing damaged wiring, correcting timing chain issues, or updating/reprogramming the ECM.

The cost depends on the specific issue. Replacing a camshaft position sensor typically costs $100–$300, while timing chain repairs or ECM updates can be more expensive.

While unlikely, a weak or dead battery causing low voltage could potentially disrupt sensor signals and trigger the code. Ensure the battery is in good condition.

Not necessarily. While timing chain issues can cause this code, it could also result from sensor failure or wiring problems.

Clearing the code may temporarily remove the Check Engine Light, but the underlying issue must be resolved to prevent it from returning.