AutoCodes - Nissan - P0345 2009 NISSAN PATHFINDER

P0345 2009 NISSAN PATHFINDER Code - Camshaft Position Sensor Circuit Bank 2

Repair Importance Level: 3/3
Repair Difficulty Level: 2/3
Table of contents

|P0345 2009 NISSAN PATHFINDER code possible causes

  • Faulty Camshaft Position Sensor
  • Camshaft Position Sensor harness is open or shorted
  • Camshaft Position Sensor circuit poor electrical connection
  • Faulty starter motor
  • Starting system circuit
  • Dead (Weak) battery

|How do I fix the P0345 2009 NISSAN PATHFINDER code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

|P0345 2009 NISSAN PATHFINDER code tech notes





User Submitted Video

|Cost of diagnosing the P0345 2009 NISSAN PATHFINDER code

Labor: 1.0

The cost of diagnosing the P0345 2009 NISSAN PATHFINDER code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.

|When is the P0345 2009 NISSAN PATHFINDER code detected?

The camshaft position sensor signal is not detected by the Engine Control Module(ECM) during the first few seconds of engine cranking

|What are P0345 2009 NISSAN PATHFINDER code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall

|P0345 2009 NISSAN PATHFINDER code description

The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.
OBDII Code P0345 2009 Nissan Pathfinder - Camshaft Position Sensor Circuit Bank 2 - AutoCodes.com

|Need more information with the P0345 2009 NISSAN PATHFINDER code?

Need more information on how to fix the P0345 2009 NISSAN PATHFINDER code? Get Access to Factory Service Manuals

|Need help with a P0345 2009 NISSAN PATHFINDER code?

Get the P0345 2009 Nissan Pathfinder code diagnosed by a professional: Find a repair shop in your area

|P0345 2009 NISSAN PATHFINDER code comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0345 2009 Nissan Pathfinder code? Have you replaced any parts?
Any information is appreciated. Thanks
Top ⇧
Repair Importance Level: 3
 
1=Low 2=Medium 3=High What is this?
Repair Difficulty Level: 2
 
1=Easy 2=Moderate 3=Hard What is this?