AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Toyota - P0341 2003 Toyota Highlander

P0341 2003 Toyota Highlander Code - Camshaft Position Sensor 'A' Circuit Low Input Bank 1

- Code Popularity: 4,014 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
By AutoCodes.com - Updated Jun 14, 2020
Share on Facebook   Share on Twitter   Share on Linkedin

|Code P0341 2003 Toyota Highlander Possible Causes

  • Faulty Camshaft Position Sensor
  • Camshaft Position Sensor harness is open or shorted
  • Camshaft Position Sensor circuit poor electrical connection
  • Faulty starter motor
  • Starting system circuit
  • Dead (Weak) battery

|How do I Fix the Code P0341 2003 Toyota Highlander?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your Toyota have Safety Recalls? → Check here

|Code P0341 2003 Toyota Highlander Tech Notes

Sometimes and in some models, low battery voltage or a weak starter can trigger a Camshaft Position Sensor code.

|What is the Cost to Diagnose the Code P0341 2003 Toyota Highlander?

Labor: 1.0

The cost of diagnosing the P0341 2003 Toyota Highlander code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|When is the Code P0341 2003 Toyota Highlander Detected?

The camshaft position sensor signal sent to the Engine Control Module(ECM) during the first few seconds of engine cranking is out of range.

|What are Code P0341 2003 Toyota Highlander Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Possible lack/loss of power
  • Engine may stall while driving

|Code P0341 2003 Toyota Highlander Description

The Camshaft Position Sensor is an electronic device used in an engine to record the rate at which the camshaft is spinning. This information is used by the Engine Control Module(ECM) to control ignition and fuel injection. The camshaft position sensor senses the retraction of camshaft (intake) to identify a particular cylinder. The camshaft position sensor senses the piston position. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
When the crankshaft position sensor (POS) system becomes inoperative, the camshaft position sensor provides various controls of engine parts instead, utilizing timing of cylinder identification signals.

OBDII Code P0341 2003 Toyota Highlander - Camshaft Position Sensor 'A' Circuit Low Input Bank 1 - AutoCodes.com
P0341 2003 Toyota Highlander Code - Camshaft Position Sensor 'A' Circuit Low Input Bank 1

|Need More Information on the P0341 2003 Toyota Highlander Code?

Need more information on how to fix the P0341 2003 Toyota Highlander code? Get Access to Factory Service Manuals

|Need Help with the P0341 2003 Toyota Highlander Code?

Get the P0341 2003 Toyota Highlander code diagnosed by a professional: Find a repair shop in your area

|Code P0341 2003 Toyota Highlander comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0341 2003 Toyota Highlander code? Have you replaced any parts?
Any information is appreciated. Thanks