| All About OBDII Engine Codes
AutoCodes - Dodge - P0336 DODGE

P0336 DODGE Code - Crankshaft Position Sensor Performace

- Code Popularity: 18,192 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
By - Updated Sep 09, 2019
Share on Facebook   Share on Twitter   Share on Linkedin

|P0336 DODGE code possible causes

  • Faulty crankshaft position sensor
  • Crankshaft position sensor harness is open or shorted
  • Crankshaft position sensor circuit poor electrical connection
  • Signal plate may be damage
  • Starter motor may be faulty
  • Starting system circuit
  • Dead or weak battery

|How do I fix code P0336 DODGE code?

Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.

Does your car have Safety Recalls? → Check here

|P0336 DODGE code tech notes

Sometimes and in some models, low battery voltage or a weak starter can trigger a Crankshaft Position Sensor code. Before replacing any parts, recharge or replaced battery.

|Cost of diagnosing P0336 DODGE code

Labor: 1.0

The cost of diagnosing the P0336 DODGE code is 1.0 hour of labor. The auto repair labor rates vary by location, your vehicle's make and model, and even your engine type. Most auto repairs shops charge between $75 and $150 per hour.

|When is the P0336 DODGE code detected?

The crankshaft position sensor (POS) signal is not detected by the Electronic Control Module (ECM) during the first few seconds of engine cranking

|What are P0336 DODGE code possible symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Lack/Loss of Power
  • Engine Stall

|P0336 DODGE code description

The Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module(ECM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.

*Sensor design may vary for your model and year

OBDII Code p0336 dodge - Crankshaft Position Sensor Performace -
P0336 DODGE Code - Crankshaft Position Sensor Performace

|Need more information with the P0336 DODGE code?

Need more information on how to fix the P0336 DODGE code? Get Access to Factory Service Manuals

|Need help with a P0336 DODGE code?

Get the p0336 dodge code diagnosed by a professional: Find a repair shop in your area

|P0336 DODGE code comments

Help us improve Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the p0336 dodge code? Have you replaced any parts?
Any information is appreciated. Thanks