AutoCodes.com | All About OBDII Engine Codes
AutoCodes - Mitsubishi - P0335 Mitsubishi

P0335 Mitsubishi Code - Crankshaft Position Sensor Circuit

- Code Popularity: 76,766 Views
- Repair Importance Level: 3/3
- Repair Difficulty Level: 2/3
Table of contents
Share on Facebook   Share on Twitter   Share on Linkedin

What are the Possible Causes of the DTC P0335 Mitsubishi?

NOTE: The causes shown may not be a complete list of all potential problems, and it is possible that there may be other causes.
  • Faulty crankshaft position sensor
  • Crankshaft position sensor harness is open or shorted
  • Crankshaft position sensor circuit poor electrical connection
  • Signal plate may be damage
  • Starter motor may be faulty
  • Starting system circuit
  • Dead or weak battery
⚠ Does your Mitsubishi have Safety Recalls? → Check here

How to Fix the DTC P0335 Mitsubishi?

Review the 'Possible Causes' mentioned above and visually examine the corresponding wiring harness and connectors. Ensure to check for any damaged components and inspect the connector pins for signs of being broken, bent, pushed out, or corroded.

Code Tech Notes

Sometimes and in some models, low battery voltage or a weak starter can trigger a Crankshaft Position Sensor code. Before replacing any parts, recharge or replaced battery.

Search for P0335 Mitsubishi Questions and Answers: Search here →

What is the Cost to Diagnose the Code?

Labor: 1.0

To diagnose the P0335 Mitsubishi code, it typically requires 1.0 hour of labor. The specific diagnosis time and labor rates at auto repair shops can differ based on factors such as the location, make and model of the vehicle, and even the engine type. It is common for most auto repair shops to charge between $75 and $150 per hour.

When is the Code Detected?

The crankshaft position sensor (POS) signal is not detected by the Electronic Control Module (ECM) during the first few seconds of engine cranking

What are Code Possible Symptoms?

  • Engine Light ON (or Service Engine Soon Warning Light)
  • Engine Lack / Loss of Power
  • Engine may stall while driving

Code P0335 Mitsubishi Description

The Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module(ECM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.

OBDII Code P0335 Mitsubishi - Crankshaft Position Sensor Circuit - AutoCodes.com
P0335 Mitsubishi Code - Crankshaft Position Sensor Circuit

Need More Information on the Code?

Need more information on how to fix the P0335 Mitsubishi code? Get Access to Factory Service Manuals

Need Help with the Code?

Get the P0335 Mitsubishi code diagnosed by a professional: Find a repair shop in your area

Code P0335 Mitsubishi comments

Help us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0335 Mitsubishi code? Have you replaced any parts?
Any information is appreciated. Thanks