P0335 2011 NISSAN ALTIMA SEDAN Code - Crankshaft Position Sensor Circuit
|P0335 2011 NISSAN ALTIMA SEDAN code possible causes
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery
|How do I fix the P0335 2011 NISSAN ALTIMA SEDAN code?Check the "Possible Causes" listed above. Visually inspect the related wiring harness and connectors. Check for damaged components and look for broken, bent, pushed out, or corroded connector's pins.
|P0335 2011 NISSAN ALTIMA SEDAN code tech notesSometimes and in some models, low battery voltage or a weak starter can trigger a Crankshaft Position Sensor code. Before replacing any parts, recharge or replace the battery.
|Cost of diagnosing the P0335 2011 NISSAN ALTIMA SEDAN code
Labor: 1.0The cost of diagnosing the P0335 2011 NISSAN ALTIMA SEDAN code is 1.0 hour of labor. The auto repair's diagnosis time and labor rates vary by location, vehicle's make and model, and even your engine type. Most auto repair shops charge between $75 and $150 per hour.
|When is the P0335 2011 NISSAN ALTIMA SEDAN code detected?The crankshaft position sensor (POS) signal is not detected by the Electronic Control Module (ECM) during the first few seconds of engine cranking
|What are P0335 2011 NISSAN ALTIMA SEDAN code possible symptoms?
- Engine Light ON (or Service Engine Soon Warning Light)
- Possible lack/loss of Power
- Engine may stall while driving
|P0335 2011 NISSAN ALTIMA SEDAN code descriptionThe Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. This information is used by the Electronic Control Module(ECM) to control ignition and fuel injection. The sensor system consists of a rotating part, typically a disc, as well as a static part, the actual sensor.
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
|Need more information with the P0335 2011 NISSAN ALTIMA SEDAN code?Need more information on how to fix the P0335 2011 NISSAN ALTIMA SEDAN code? Get Access to Factory Service Manuals
|Need help with a P0335 2011 NISSAN ALTIMA SEDAN code?Get the P0335 2011 Nissan Altima Sedan code diagnosed by a professional: Find a repair shop in your area
|P0335 2011 NISSAN ALTIMA SEDAN code commentsHelp us improve AutoCodes.com. Leave a comment below or tell us if the information above helps you fix the code. What are the symptoms on your vehicle for the P0335 2011 Nissan Altima Sedan code? Have you replaced any parts?
Any information is appreciated. Thanks