P0335 2010 Nissan Pathfinder Code - Crankshaft Position Sensor Circuit
Quick Answer
The Crankshaft Position Sensor (CKP) also known as the crank position sensor is an electronic device used in an engine to record the rate at which the crankshaft is spinning. Common causes include Faulty crankshaft position sensor, Crankshaft position sensor harness is open or shorted, Crankshaft position sensor circuit poor electrical connection. Severity is High - diagnose this code as soon as possible. Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
- What it means
- P0335 2010 Nissan Pathfinder indicates Crankshaft Position Sensor Circuit.
- Common causes
- Common causes include Faulty crankshaft position sensor, Crankshaft position sensor harness is open or shorted, Crankshaft position sensor circuit poor electrical connection.
- Severity
- High - diagnose this code as soon as possible.
- Can I drive?
- Driving is not recommended if the warning light is flashing, the engine runs poorly, or safety-related symptoms are present.
Code P0335 2010 Nissan Pathfinder Description
When the engine is running, the high and low parts of the teeth cause the gap with the sensor to change. The changing gap causes the magnetic field near the sensor to change. The change in the magnetic field cause the voltage from the sensor to change.
What are the Possible Causes of the DTC P0335 2010 Nissan Pathfinder?
- Faulty crankshaft position sensor
- Crankshaft position sensor harness is open or shorted
- Crankshaft position sensor circuit poor electrical connection
- Signal plate may be damage
- Starter motor may be faulty
- Starting system circuit
- Dead or weak battery
How to Fix the DTC P0335 2010 Nissan Pathfinder?
Review the 'Possible Causes' above and visually examine the corresponding wiring harness and connectors. Check for damaged components and inspect connector pins for signs of being broken, bent, pushed out, or corroded.
Code Tech Notes
What is the Cost to Diagnose the Code?
Labor: 1.0
To diagnose the P0335 2010 Nissan Pathfinder code, it typically requires 1.0 hour of labor. Rates vary by location, vehicle, and shop. Many shops charge between $80–$150 per hour; dealerships and metro areas may be higher, independents may be lower.
Need more information about the P0335 2010 Nissan Pathfinder code?
Need more information on how to fix the P0335 2010 Nissan Pathfinder code? Get Access to Factory Service Manuals
Need Help with the Code?
Get the P0335 2010 Nissan Pathfinder code diagnosed by a professional: Find a repair shop in your area
Frequently Asked Questions about P0335 2010 Nissan Pathfinder Code
1. What does the OBDII code P0335 mean on a 2010 Nissan Pathfinder?
P0335 indicates an issue with the crankshaft position sensor circuit, which means the Engine Control Module (ECM) is not receiving proper signals from the sensor.
2. What are the symptoms of a P0335 code on a 2010 Nissan Pathfinder?
Common symptoms include difficulty starting the engine, engine stalling, poor acceleration, rough idling, and the Check Engine Light turning on.
3. What causes the P0335 code to appear on my 2010 Nissan Pathfinder?
Possible causes include a faulty crankshaft position sensor, damaged wiring or connectors in the sensor circuit, a failed ECM, or issues with the timing components.
4. Can I drive my 2010 Nissan Pathfinder with a P0335 code?
Driving with a P0335 code is not recommended as it may lead to stalling, reduced performance, or further engine damage.
5. How do I fix the P0335 code on a 2010 Nissan Pathfinder?
Repairs may include replacing the crankshaft position sensor, repairing or replacing damaged wiring or connectors, or reprogramming or replacing the ECM if necessary.
6. Where is the crankshaft position sensor located on a 2010 Nissan Pathfinder?
The crankshaft position sensor is typically located near the bottom of the engine, close to the crankshaft, often near the transmission bell housing.
7. How much does it cost to fix the P0335 code on a 2010 Nissan Pathfinder?
The cost varies but typically ranges from $150 to $300, including parts and labor, depending on the repair needed.
8. Can a bad crankshaft position sensor cause a no-start condition?
Yes, if the crankshaft position sensor fails completely, the engine may not start because the ECM cannot determine the crankshaft's position.
9. How can I diagnose the P0335 code on my 2010 Nissan Pathfinder?
Diagnosis involves using an OBDII scanner to confirm the code, visually inspecting the sensor and wiring, testing the sensor with a multimeter, and checking for proper signal output.
10. Is it common for the crankshaft position sensor to fail on a 2010 Nissan Pathfinder?
Crankshaft position sensor failure is not uncommon in older vehicles, especially if the sensor has been exposed to heat, oil leaks, or wear over time.
Discuss the causes and fixes for P0335 2010 Nissan Pathfinder OBDII Code
-
I've replaced the sensor still no start I replaced the crank position sensor still hard to start, checked batt full charge
Fix Your Car Smarter
Try the New AutoCodes App!
Get complete OBDII diagnostics, repair solutions, and cost estimates, plus AI chat support on demand.
